User manual YAMAHA B2R

[. . . ] 7FH:on (3) Local Control (reception only) ccH Parameter Data Range (vvH) 7AH Local Control 00H (off), 7FH (on) (4) All Notes Off ccH Parameter Data Range (vvH) 7BH All Notes Off 00H Switches OFF all the notes that are currently ON on the specified channel. Any notes being held by the sustain or sostenuto pedal will continue to sound until the pedal is released. € When Control Change is turned OFF, Control Change messages will not be transmitted or received. [. . . ] € When Control Change is turned OFF, Control Change messages will not be transmitted or received. • Local on/off , OMNI on/off are not transmitted. (The appropriate note off number is supplied with “All Note Off” transmission). € When a voice bank MSB/LSB is received, the number is stored in the internal buffer regardless of the received order, then the stored value is used to select the appropriate voice when a program change message is received. This mode will not change when the instrument receives a MONO/POLY mode message. 7FH (12) RPN 65H RPN MSB 64H RPN LSB 06H Data Entry MSB 26H Data Entry LSB 60H Data Increment 61H Data Decrement * Parameters that are controllable with RPN: • Coarse Tune • Fine Tune • Pitch Bend Range 2 B2R MIDI Reference / MIDI-Referenz / Référence MIDI / Referencia MIDI MIDI Data Format / MIDI-Datenformat / Format des données MIDI / Formato de datos MIDI 4. € When a MIDI master volume message is received, the volume only has affect on the MIDI receive channel, not the panel master volume. 4CH = Model ID of XG hhH = Address High mmH = Address Mid llH = Address Low ddH = Data | F7H = End of Exclusive Data size must match parameter size (2 or 4 bytes). When the XG System On message is received, the MIDI system will be reset to its default settings. The message requires approximately 50ms to execute, so sufficient time should be allowed before the next message is sent. Allow sufficient time for processing to execute (about 50 msec) before sending the instrument another message. € XG Native Parameter Change message may contain two or four bytes of parameter data (depending on the parameter size). • For information about the Address and Byte Count values , refer to Table 1 below. Note that the table’s Total Size value gives the size of a bulk block. [. . . ] • For information about the Address and Byte Count values , refer to Table 1 below. Note that the table’s Total Size value gives the size of a bulk block. Only the top address of the block (00H, 00H, 00H) is valid as a bulk data address. [. . . ]