User manual YAMAHA CA-2010

[. . . ] Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the unit to rain or water. If something drops into the set, contact your dealer. Do not use force on switches, controls or connection wires. [. . . ] 65 36 SET MENU Items The SET MENU consists of eighteen items including the Speaker Set, Center Graphic Equalizer and Parameter Initialization features. Choose the appropriate item and adjust or select the values as necessary. Notes: English · You can adjust the items in the SET MENU while reproducing a source. · We recommend that you adjust the items in the SET MENU while using a video monitor. It is easier to see the video monitor screen than it is to see the front panel display on this unit while adjusting SET MENU items. Items 1. TEST Descriptions Setting (Bold as default) Page Selects the output mode suitable for your Center speaker. Selects the output mode suitable for your Main speakers. Selects the output mode suitable for your Rear speakers. Selects the output mode suitable for your Rear Center speaker. Selects the speakers for your LFE/BASS signal output. Selects the output mode for your Front Effect speakers. Selects the output level for your main channels. MAIN LEVEL) Use this feature to select suitable output modes for your speaker configuration. You must set the output mode when you use a subwoofer. English s 1A. CENTER SP (Center Speaker Mode) By adding a Center speaker to your speaker configuration, the CA-2010 can provide good dialogue localization for many listeners and superior synchronization of sound and images. The OSD shows a large, small or no center speaker depending on how you set this item. The initial setting is "LRG". Select the "LRG" (Large) setting if you have a large Center speaker. The entire range of Center channel signals is sent to the Center speaker. Select the "SML" (Small) setting if you have a small Center speaker. Center channel low frequency signals of 90 Hz and below are directed to the speakers selected with the 1E. Select the "NONE" setting if you do not have a Center speaker. All of the Center channel signals are directed to the left and right Main speakers. The "NONE" position provides good dialogue localization for the person sitting in the main listening position. Large Small None s 1B. [. . . ] models] MAIN L/R (1 kHz, 0. 015 % THD, 8 ohms) ---------- 120 W Power Band Width MAIN L/R (55 W, 0. 04% THD, 8 ohms) --------------------------------------------------- 10 Hz to 50 kHz Damping Factor MAIN L/R (20 Hz to 20 kHz, 8 ohms) --------- 200 or more Input Sensitivity/Impedance (110 W/8 ohms) CD, etc. ------------------------------------- 150 mV/47 k-ohms PHONO MM ------------------------------- 2. 5 mV/47 k-ohms MAIN IN ----------------------------------------- 1 V/47 k-ohms Output Level/Impedance REC OUT ----------------------------------- 150 mV/600 ohms MAIN OUT ------------------------------------- 1 V/1. 2 k-ohms SUBWOOFER [SPLIT L/R] ----------------- 2 V/1. 2 k-ohms [MONO] ------------------ 4 V/1. 2 k-ohms PHONES Output ------------------------------------ 150 mV/100 ohms Frequency Response (10 Hz to 100 kHz) CD, etc. OUT ------------------------ ­3 dB Total Harmonic Distortion (20 Hz to 20 kHz) CD, etc. to MAIN OUT (1 V) ----------------- 0. 005% or less MAIN IN to SP OUT (55 W/8 ohms) -------- 0. 005% or less Signal to Noise Ratio (IHF-A network) (Input shorted, EFFECT off) ------------------ 96 dB or more Residual Noise (IHF-A network) MAIN L/R SP. [. . . ]