User manual YAMAHA CC-90

[. . . ] Natural Sound Mini Component System CC-90 EMPTY Active Servo Technology CC-90 is composed of CTX-S90, MX-S90, CDC-S90, KX-S90 and NX-S90. IMPORTANT!Please record the serial number of this unit in the space below. Model: Serial No. : OWNER'S MANUAL CONTENTS Page SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . Inside Front Cover-1 INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 FEATURES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 SUPPLIED ACCESSORIES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 NAMES OF CONTROLS, INDICATORS AND REAR PANEL PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6 REMOTE CONTROL TRANSMITTER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-9 REMOVING THE FRONT GRILLE (for Speaker System NX-S90 only). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 PREPARATION FOR USE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10-12 OPEN/CLOSE THE CONTROL DOOR. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13 TURNING THE POWER ON/OFF TO THIS SYSTEM . . . . . . . . . 13 SETTING THE CLOCK. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 The serial number is located on the rear of the unit. Retain this Owner's Manual in a safe place for future reference. Page SOUND CONTROL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 COMPACT DISC PLAYER OPERATION. . . . . . . . . . . . . . . . . . . . . . . . 15-22 TUNING OPERATION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23-25 TAPE DECK OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 26-28 RECORDING COMPACT DISCS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 29-34 OTHER RECORDINGS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 35-36 HOW TO USE THE BUILT-IN TIMER . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 37-40 USING EXTERNAL UNITS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 41-42 MAINTENANCE. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 42 SPECIFICATIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43 TROUBLESHOOTING. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44 ACTIVE SERVO TECHNOLOGY (for Speaker System NX-S90 only). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45 SAFETY INSTRUCTIONS (for U. S. [. . . ] * If, for example, the number of received FM stations is not enough to fill up three areas (A, B and C), AM (MW or LW) stations are programmed closely from the preceeding empty areas. In such a case, AM (MW) stations are programmed from area B or C (and LW stations are from area C or D. ) * Moreover, one area is programmed with stations of the same band only. If, for example, the last FM station is programmed to B4, B5­B8 will be programmed with no station, and AM (MW) stations are programmed from area C. Memory back-up The memory back-up circuit prevents the programmed data from being lost even if the AC supply lead is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is cut for more than one week, the memory may be erased. If so, it can be reprogrammed by simply following the Preset tuning steps. 25 TAPE DECK OPERATION General information · · · Do not use C-120 tapes, tapes with internal reels or poorquality tapes, since they can cause malfunctions. Before loading a tape into the cassette compartment, tighten the slack tape with a pen or pencil. Tapes have removable tabs which prevent accidental recording or erasing from taking place. Removing the tab on the top left protects the side facing you from erasure. Cover the tab holes with adhesive tape to erase or record again. This deck is a Single Cassette Deck with Automatic Reverse Function. This deck features an auto tape selector. Just load the tape, and the tape formula being used will be sensed automatically. This unit can play back metal tapes as well as normal or chrome tapes, and recording can also be done on metal tapes. When covering erasure prevention tab holes, do not cover the chrome and metal detection holes. Otherwise, the deck will treat tape as normal tape. Do not press the OPEN/CLOSE button during playback or recording. · · · · Detection hole Tab · Tape playback Preamplifier/Tuner 1 2 3 4 Press the TAPE input selector button. Open the cassette compartment by pressing the OPEN/CLOSE button. Load the tape into the cassette compartment. Set the Dolby NR switch to B or C if the tape has been recorded with Dolby noise reduction, and to OFF if Dolby NR was not used. * For selection of the Dolby B or C position, refer to the "Dolby B and C Type Noise Reduction" on page 27. Set the reverse mode switch as desired. 1 3 Side A upward. 5 The reverse mode switch can be operated before or during playback, and changes tape playback as follows: Side A only Side A Side B Side A Side B Continuous play (8 times) Side B Side A Continuous play (8 times) Tape Deck Side B only Side B only EMPTY 6 64 5 2 26 Press the play button to listen to side A, or the play button for side B. 6 TAPE DECK OPERATION To stop playback Press the stop button. Note When removing the tape, press the stop open the cassette compartment. button, and then Direct operation Even if an input source other than tape deck is selected, pressing the play button (or the fast wind button) will start playback (or fast winding) directly. Tape Counter (LINEAR COUNTER) and RESET button This unit is equipped with a tape counter which is useful for searching and locating a desired point on tape. The tape counter is displayed by minutes and seconds, though the displayed time is not so close to the actual elapsed time. [. . . ] Head is dirty. Sound is distorted or fades out. Head is dirty. Tape is worn. TAPE DECK Poor sound quality. Excessive noise. Dolby NR switch is set to wrong position. Tape is worn. Tape travel stops in middle of playback or recording. Slack tape coming out of cassette shell. [. . . ]