User manual YAMAHA CD-N500

[. . . ] 1 2 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this sound system in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. For proper ventilation, allow the following minimum clearances. [. . . ] Remote control 1 2 3 Numeric buttons 4 5 6 7 8 9 0 PROGRAM CLEAR SHUFFLE REPEAT A/B / / / / ENTER ENTER RETURN HOME NOW PLAYING RETURN SETUP MODE SETUP Main unit SELECT PUSH ENTER RETURN RETURN English Front panel display 1 Network Configuration 23 En SETUP MENU Setup menu list Menu Submenu Settings (Bold: default) On, Off Function Select “On” to use the DHCP server to automatically configure the network settings of this unit or “Off” to configure manually. Specify the IP address when “DHCP” is “Off”. *1 Specify the subnet mask when “DHCP” is “Off”. *1 Specify the default gateway when “DHCP” is “Off”. *1 Specify the primary DNS server when “DHCP” is “Off”. *1 Specify the secondary DNS server when “DHCP” is “Off”. *1 The MAC address of this unit is shown. The MAC address is also used as a vTuner ID. The network status of this unit is shown (“Connected” or “Not connected”). on , Off 4 Hours , 8 Hours , 12 Hours , Off –3 to 0 Select “On” to enable the network standby mode. This unit automatically enters standby mode if it is left turned on for the selected time without playback or any other operation being performed. Adjust the brightness of the front panel display. The firmware version of this unit is shown. Network, USB Update the firmware of this unit after selecting “Network” or “USB”. when “Press ENTER to start” appears , press ENTER to start firmware update. Do not operate this unit until “UPDATE SUCCESS” appears. Then turn off this unit once and turn it on again. DHCP IP Address Subnet Mask Network Configuration Default Gateway DNS Server (P) DNS Server (S) MAC Address Network Information Status System ID Network Standby Auto Power Down Dimmer Firmware Version Firmware Update *1: When “DHCP” is “On”, you can check the values (IP address, etc. 24 En SETUP MENU Advanced setup menu The following menu items are available only when you enter the setup menu by pressing SETUP (on the remote control) while holding down RETURN (on the main unit). Settings (Bold: default) On, Off Menu Function Select “On” to specify the MAC addresses (up to 5) of the network components that will be permitted access to this unit (“Address1” to “Address5”). Select “Off” to disable the MAC address filter function. This function works on “SERVER” audio contents only. [. . . ] revocation does not affect unprotected content. When you download licenses for protected content, you agree that Microsoft may include a revocation list with the licenses. Content owners may require you to upgrade WMDRM to access their content. If you decline an upgrade, you will not be able to access content that requires the upgrade. [. . . ]