User manual YAMAHA CDR-1000

[. . . ] PROFESSIONAL AUDIO CD RECORDER Owner's Manual PROFESSIONAL AUDIO CD RECORDER OPEN/ CLOSE PEAK HOLD INPUT TIME DISPLAY SELECT REC LEVEL UTILITY POWER REC MUTE UV22 REPEAT A-B SYNC REC AUTO INDEX INC TRACK INC 0 L R 10 ON / OFF PHONES LEVEL PREV ERASE FINALIZE NEXT INDEX SEARCH PAUSE STOP PLAY REC 0 10 FOOT SW PHONES Keep This Manual For Future Reference. E FCC INFORMATION (U. S. A. ) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. [. . . ] All-track Repeat playback starts and "REPEAT ALL" appears on the display. Press the [REPEAT] button to cancel All-track Repeat playback. Normal playback resumes and "REPEAT ALL" disappears from the display. 2 A-B Repeat Playback 1 Press the [A-B] button to set the A point. The A point is set and "REPEAT A" appears on the display. The A and B points can be in the same track or in different tracks. Press the [A-B] button again to set the B point. Playback repeats between the A and B points and "REPEAT AB" appears on the display. Press the [A-B] button again to cancel A-B Repeat playback. Normal playback resumes and "REPEAT AB" disappears from the display. 2 3 CDR1000--Owner's Manual Recording 25 5 Recording Preparing to Record The CDR1000 can record onto CD-R and CD-RW discs. 1 Load the disc to be used for recording. See "Loading & Unloading Discs" on page 18 for more information. See "Selecting the Input Source" below for more information. If recording via the AES/EBU IN or COAXIAL IN, set the sampling rate converter as necessary. See "Setting the Sampling Rate Converter" on page 26 for more information. See "Setting the Copy Bit" on page 28 for more information. See "Setting the UV22" on page 28 for more information. See "Setting the Input Delay" on page 27 for more information. Proceed to Recording on page 29. 2 3 4 5 6 7 Selecting the Input Source The following input sources can be selected for recording: ANALOG IN, AES/EBU IN, or COAXIAL IN. The selected source is indicated on the display. 1 Use the [INPUT SELECT] button to select an input source. Setting ANALOG AES/EBU COAX ANALOG IN (analog) AES/EBU IN (AES/EBU digital) COAXIAL IN (S/PDIF digital) Description When a digital input source is selected, the LOCK indicator lights up, indicating that the CDR1000 is locked to the incoming signal. If the CDR1000 cannot lock to the selected digital input source, the LOCK indicator flashes. If this unlocked condition continues for more than five seconds while recording, recording stops. If this happens, make sure that the source device is turned on and connected to the CDR1000 correctly, or select another input source. Recording via the AES/EBU IN or COAXIAL IN is not possible while the LOCK indicator is flashing. CDR1000--Owner's Manual 26 Chapter 5--Recording Setting the Sampling Rate Converter The CDR1000 features a built-in sampling rate converter (SRC), which means digital sources at sampling rates other than 44. 1 kHz, the standard for audio CDs, can be recorded. [. . . ] If the error cannot be fixed by opening or closing the disc tray, and the error remains even after powering off and on, contact your Yamaha dealer. If the error remains even after powering off and on, contact your Yamaha dealer. 2 1 Remarks CDR1000--Owner's Manual Specifications 55 Specifications Recording media Playback media Sampling rate Recording resolution Converters A/D D/A Frequency response Track Index SRC (Sampling Rate Converter) 16-bit encoding S/N Input delay Fade in/out time Synchronized recording Repeat playback Locate Type Characters Time counter Display Display mode Track counter Index counter Level meters Power requirements Power consumption Dimensions (W × H × D) Weight Free-air operating temperature range Relative humidity Accessories Options CD-R, CD-RW CD, CD-R, CD-RW 44. 1 kHz 16-bit linear 20-bit 64-times oversampling 20-bit 128-times oversampling 20 Hz­20 kHz Up to 99 tracks Up to 99 indexes 30 kHz to 50 kHz UV22 97 dB 0­4, 950 ms 0­10 second CD, MD, DAT One track, All track, A­B PREV, NEXT, INDEX, SEARCH, direct select VFD (Vacuum Fluorescent Display) 12-character line Minutes and seconds Elapse, Remain, Total 0­99 0­99 16 segment with CLIP indicator x2 U. S. A. & Canada 120 V AC, 60 Hz Europe 230 V AC, 50 Hz 33 W 480 × 101 × 389 mm (18. 9 x 4 x 15. 3 inches) 8 kg (17. 6 lbs) 5° C to 35° C (41° F to 95° F) 10%­95% Power cord, remote controller, batteries (size AA, R6, UM-3 x2), transportation pad, Owner's Manual Yamaha FC5 footswitch CDR1000--Owner's Manual 56 Appendix Analog Input Connection ANALOG IN1 1. * * Impedance 20 k Input Level ­10 dBV/+4 dB2 Max. [. . . ]