User manual YAMAHA CD-R200TIPC QUICK START GUIDE

[. . . ] GETTING STARTED CDR400ti-PC & CDR200ti-PC ©1997 Yamaha Corporation. This document may not, in whole or in part, be copied, photocopied, reproduced, translated, transmitted or reduced to any electronic medium of machine readable form without prior consent in writing from Yamaha. MS-DOS and Windows are registered trademarks of Microsoft, Inc. EasyCD Pro 95/NT, DirectCD, Toast are registered trademarks ofAdaptec, Inc. [. . . ] Always try to handle circuit boards and cards by the edges. Refer to the documentation provided with your computer for instructions on opening the computer case. Open the case according to manufacturer's instructions. Page 7 4. Most computers will have a blank cover plate over the empty drive bay. These plates typically snap into place although some may be secured by screws (see your computer's documentation). Remove the cover plate. Note: The drive bays of most computers will accommodate the CD-R drive directly. Some computers may require an accessory rail or mounting bracket. These components are available from the computer manufacturer. 5. If space is tight inside your computer, you may wish to connect the audio output cable, the power supply cable, and the SCSI ribbon cable before sliding the CD-R all the way into the bay. Page 8 6. Connect the supplied audio cable to the audio output of the CD-R. Connect the other end of the audio cable to your soundcard. Some sound cards may have only one internal audio input which is probably already occupied by the audio output of your CD-ROM drive. If this is the case, it is best to leave the CD-ROM drive connected to the soundcard. Note: Your CD-R will be fully functional without any connection to the soundcard ­ except that you will not be able to play an audio CD on the CD-R and hear it through your soundcard. You will be able to listen to an audio CD via the headphone jack on the CD-R. And, of course you can still play back an audio CD on your CD-ROM drive. 7. Connect the SCSI Ribbon cable to the CD-R. Note that the CD-R has an arrow on the right side of the SCSI connector. This arrow should point to the red line on the SCSI cable. Connect the other end of the ribbon cable to the SCSI controller card. 8. Locate one of the DC power connectors inside your computer (a 4-pin connector with (usually) a yellow, a red, and two black wires). Connect this cable to the power supply input of the CD-R. Page 9 9. Slide the CD-R the rest of the way into the bay and install the four 3mm mounting screws and washers from the sides. 10. [. . . ] Please contact Yamaha directly if you have any questions regarding the Yamaha limited warranty. This limited warranty is applicable only in the fifty states of the USA and the District of Columbia. It is not applicable in the possessions or territories of the USA or in any other country. THIS LIMITED WARRANTY IS THE ONLY WARRANTY WHICH YAMAHA MAKES WITH RESPECT TO YOUR CDR200 / 400 SERIES CDRECORDABLE DRIVE. [. . . ]