User manual YAMAHA CH-500

[. . . ] Before you use the chime, carefully read the instructions listed below and the owner's manual. Never lean on or climb onto the instrument. the instrument may fall and result in injury. [. . . ] Injury or handicaps to persons caused by the disregard of warnings with this mark or, misuse of the instrument, may result in the loss of personal property. Do not use the hammer for anything other than playing the instrument. it may be the cause of injury or accidents. Do not allow such dangerous behavior to take place. When assembling or disassembling the instrument, be careful around the sides or ends of metal parts so as to prevent injury to fingers, etc. If the instrument is often moved, bolts, parts, etc. After moving the instrument, check and make sure all bolts, parts, etc. 1 Never use a metal type hammer or mallets to strike the sound column with. 2 Always use the instrument on a flat, level surface. the instrument will not function properly on a sloped surface. 3 When assembling the stand, make sure each part is firmly attached, and there is no twisting or disfigurement in the frame. Also, make sure that all wing nuts are firmly tightened. 4 Use your toes to operate the damper pedal. Do not stand on or put your weight on the pedal. Moving the adjuster may result in the damper not functioning properly. 6 When playing the chime, make sure the caster brakes are firmly set and the chime stand does not move about. [. . . ] Before hanging the sound columns on the hanger, activate the damper stopper. Position the sound column with its pitch inscription facing forward, place one side of the wire/strings into the slot of the fixing pin. Next, hook the wire/ strings on the hanger pin, finally place the wire/ strings into the slot of the remaining fixing pin. [. . . ]