User manual YAMAHA CLP-500E

[. . . ] To change the setting use a "minus" screwdriver to rotate the selector dial so that the correct voltage appears next to the pointer on the panel. For information on assembling the keyboard stand, refer to the instructions at the end of this manual. EN Introduction SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. Battery Notice: This product MAY contain a small non- rechargable battery which (if applicable) is soldered in place. [. . . ] Flanger Adds swell effects of an ascending or descending jet plane. Setting the chorus depth [ChorusSend]* See the procedure on page 69. A B Setting the reverb depth [ReverbSend]* TIP The reverb effect is not applied if the ReverbSend parameter is set to "0. " Main ChorusSend C Set?--> 48 NO YES D In Dual mode: See the procedure on page 69. A B A B MainxLayer Set?--> ChorusSend(E. Piano1) 72 YES C NO YES Main ReverbSend C Set?--> 14 NO D D Voice for editing (Voice 1 or Voice 2) In Dual mode: A B Setting range: 0 - 127 YES MainxLayer Set?--> ReverbSend(E. Piano1) 26 C NO D Voice for editing (Voice 1 or Voice 2) Setting range: 0 - 127 CLP-280/270 Owner's Manual 77 Detailed Settings Detailed settings for the voices [VOICE SETTING] Setting the chorus on/off [ChorusOnOff] You can set the [CHORUS] button on or off for each voice. When you select a voice, the chorus on/ off setting for the voice automatically changes according to this parameter. TIP Even if this parameter is turned on, the chorus effect is disabled if the ChorusSend parameter is set to 0. SoundBoard Off Simulates the reverberation of a piano soundboard. No effect. Setting the speed of the vibraphone vibrato effect* [VibeRotorSpeed] TERMINOLOGY Rotor= The rotating portion of an electrical device etc. See the procedure on page 69. Detailed Settings A B Main ChorusOnOff C Set?--> Off NO YES D This will be displayed only if VibeRotor is selected for the DSP Type parameter explained above. This sets the speed of the vibrato effect that is applied when you have selected Vibraphone and are using the VibeRotor pedal. See the procedure on page 69. A B Setting range: On/Off C Main VibeRotorSpeed Set?--> 6 NO YES D Selecting the DSP type* [DSP Type (DSP)] You can select other effects (than reverb and chorus). See the procedure on page 69. A B Setting range: 1 - 10 Turning the vibraphone vibrato effect on/off* [VibeRotorOnOff (RotorOnOff)] This will be displayed only if VibeRotor is selected for the DSP Type parameter explained above. It turns on/off the vibrato effect that is applied when you use the VibeRotor pedal. See the procedure on page 69. A B Main DSP Type C Set?--> DelayLCR NO YES D Setting range: DelayLCR Delay applied at left, center, and right positions. DelayLR Delay applied at left and right positions. Echo Echo-like delay CrossDelay Left and right delays are crossed. Symphonic Adds a rich and deep acoustic effect. Dynamic Damper Effect simulates the sustain sound that occurs when you press the damper pedal of a grand piano. The internal microphones are not used, but the sound produced within the Clavinova is processed to create a spacious sensation, as you press the damper pedal and play the keyboard. See the procedure on page 69. A B iAFC On C NO YES D Setting range: On/Off DynDmpFX Depth 98 C NO YES D Setting range: 0 - 127 CLP-280/270 Owner's Manual 81 Detailed Settings Detailed settings for iAFC [iAFC SETTING] Adjusting the Spatial Effect depth [SpatialFX Depth] Spatial Effect is one type of the iAFC effect. Spatial Effect creates a sense of reverberation and spaciousness by picking up the output sound using internal microphones and output the sound from the speaker on the rear of the instrument. The spread and spaciousness of the sound is different depending on the depth. For lower depth settings, this creates the resonance and enhances the acoustic realism of the sound that is characteristic of acoustic instruments by creating a virtual soundboard. For deeper depth settings, the sound of the instrument itself and the sound of singing and other instruments played nearby is picked up by internal microphones, and processed to simulate the spatial characteristics of performing together on stage. See the procedure on page 69. A B Restoring the default calibration setting [iAFC Default] This sets the calibration function to the default setting. See the procedure on page 69. A B iAFC Default C Set?--> NO YES D Detailed Settings SpatialFX Depth 10 C NO YES D Setting range: 0 - 127 Calibration (automatic adjustment) [Calibration] This automatically adjusts the sensitivity and response of iAFC so that the optimal iAFC effect will be obtained. When automatic adjust begins, a test sound (noise) will sound for about five seconds. While automatic adjustment is being performed, do not make audible noises in the vicinity of the Clavinova. [. . . ] 11/F. , Silvercord Tower 1, 30 Canton Road, Tsimshatsui, Kowloon, Hong Kong Tel: 2737-7688 ITALY Yamaha Musica Italia S. P. A. Viale Italia 88, 20020 Lainate (Milano), Italy Tel: 02-935-771 INDONESIA PT. Yamaha Music Indonesia (Distributor) PT. Nusantik Gedung Yamaha Music Center, Jalan Jend. [. . . ]