User manual YAMAHA CP-80

[. . . ] Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. [. . . ] When Neo:6 Music is selected ADVANCED OPERATION Adjusts the Compressed Music Enhancer effect level. When the high-frequency signals of the source is emphasized too much, set the effect level to "Low. " To reduce the effect, set this parameter to "Low. " To increase the effect, set it to "High. " C. Image Adjustable range: 0. 0 to 0. 3 to 1. 0 Adjusts the front left and right channel output relative to the center channel to make the center channel more or less dominant as necessary. ADDITIONAL INFORMATION APPENDIX English 37 En Operating various settings for this unit (Setup menu) You can call the setup menu using the remote control and change the settings of various menus. You can change the following settings in the setup menu. For details, read "Basic operation of the setup menu" first, and see the respective pages. Menu/Submenu Speaker Setup 1 Auto Setup (YPAO) 2 Manual Setup A)Config Sets items for speakers. Automatically adjusts output characteristics of speakers. Manually adjusts output characteristics of speakers. Sets speaker configurations, such as connection status of speaker and a size of the connected speaker (sound reproduction capacity), suitable for the listening environment. Separately adjusts volume of each speaker. Adjusts timing at which each speaker outputs sound based on distances between speakers and the listening position. Selects an equalizer that adjusts speaker output characteristics. Adjusts dynamic ranges of speakers and headphones. y · The default settings are marked with "*. " BASIC OPERATION 1 2 Press lSETUP on the remote control. Select a menu using nCursor k / n, and press nENTER. Items of the selected menu are displayed. For example, the following screen appears when you select "Function Setup. " ;Function Setup . 1 2 3 4 HDMI Display Volume Input Rename 1 Auto Setup Automatically adjusts output characteristics of speakers to obtain optimum balance for the output sound based on positions and performances of the speakers and acoustic characteristics or the room, which are automatically measured. For details on operations, see page 18. ADVANCED OPERATION 2 Manual Setup Adjusts output characteristics of speakers based on manually set parameters. After Auto Setup (YPAO) is performed, you can check automatically adjusted parameters in the Manual Setup menu. Fine adjust the parameters for your preference if necessary. A)Config Sets speaker configurations, such as connection status of speaker and a size of the connected speaker (sound reproduction capacity), suitable for the listening environment. y · The speaker configuration includes items for defining a speaker size: Large or Small. Large and Small refer to speakers with woofer diameters 16 cm or larger and smaller than 16 cm, respectively. ADDITIONAL INFORMATION [ [ ]/[ ]:Up/Down [ENTER]:Enter [ y · You can return to the previous screen by pressing nRETURN. 3 To display submenus, select a menu that you want to set using nCursor k / n, and press nENTER. For example, the following screen appears when you select "2 Display. " 2 Display . [. . . ] 41 Surround back left speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Surround back right speaker . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Surround back speaker . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Surround decoder editing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]