User manual YAMAHA CRW4260TIPC

[. . . ] CRW4260t SERIES User Guide Guide de I'utilisateur Bedienungsanleitung COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party: Address: Telephone: FAX: Type of Equipment: Model Name: Yamaha Systems Technology, Inc. 100 Century Center Court San Jose, California 95112 (408) 467-2330 (408) 437-8791 CD Recorder CRW4260t-B CRW4260t-NB This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. [. . . ] For both types of media, this drive is able to read at 6X speed, quad speed, double speed, or normal speed, and any of these modes can be selected as desired. s Compatible with Seven Different Formats The CRW4260t can both record and read seven different formats: CD-ROM, CD-ROM XA, CD-I, CD-DA, CD-Bridge (multisession), CDExtra, and Video CD. The CRW4260t is also equipped with an analog audio output terminal (headphones) for CD-DA. s SCSI 2 for High-Volume, High-Speed Data Transfer The CRW4260t features SCSI 2, the second generation SCSI interface for connecting computers and peripheral devices. s Compatible with Windows 95 Plug and Play SCSI IDs are set automatically by the SCAM protocol (level 1). s Orange Book Part 2, Part 3 Compatible 5-Mode Recording The CRW4260t conforms to the five recording modes outlined in the Orange Book Part 2 and Part 3: Track at Once, Multisession, Disc at Once, Session at Once, and Packet Writing. 1 Introduction Orange Book Compatible Recording Track at Once In this mode, data can be recorded to disc one track at a time. Discs recorded in this mode cannot be played in CD players or CD-ROM drives other than a CD-RW or CD-R drive until the session is closed. Multisession In this mode, data can be recorded to disc in stages (one session at a time). Additional data can be written later. Disc at Once In this mode, data can be recorded to an entire disc in one pass. It is not possible to write additional data later. Session at Once In this mode, data can be recorded to disc one session at a time. To use this mode, your software must support Session at Once recording. New sessions can be written later. Packet Writing This is useful for data back-up. Smaller units of data can be added to tracks. To use this mode, your software must support Packet Writing. The CRW4260t supports both sequential and random packet writing. 2 Chapter 1 - System Configuration Chapter 1 - System Configuration Before using the CRW4260t, make sure that you have all of the items on the list of included items. In order to use the CRW4260t, you will require the following. Computer The following operating environment is required: · An IBM/AT compatible computer with a 100 MHz or faster Pentium CPU (in order to write at 4x speed), or a 100 MHz or faster 486 CPU (in order to write at 2x speed) A vacant slot in which to install a SCSI card or a pre-installed SCSI card A vacant half-height bay Windows 3. 1, Windows 95, Windows NT4. 0 or Higher Sufficient hard disk space · · · · Note: You will need about twice as much space on your hard disk as that required by the data you wish to write to CD-ROM. SCSI card This is required in order to connect a SCSI device (the Yamaha CRW4260t) to your computer. We recommend the following: Adaptec SCSI cards: AHA-2940 (PCI), AHA-284x (VL), AHA-2740 (EISA), AHA-154x (ISA), etc. Software Use writing software or packet writing software which supports the CRW4260t. 3 Chapter 1 - System Configuration Tools · Phillips screwdriver This is used to remove the cover of your computer, and to install the Yamaha CRW4260t drive. · Long nose pliers Phillips screwdriver These are used to insert or remove the jumper pin when setting the SCSI ID and parity settings etc. of the Yamaha CRW4260t drive. Long nose pliers Discs On the CRW4260t, you can use conventional CD-RW and CD-R discs that conform to the Recordable Compact Disc Systems Part 2 and Part 3 (Orange Book). Yamaha recommends the following Yamaha CD-RW and CD-R discs: CD-RW Discs > CRWM74R (120mm, 74 minutes) CD-R Discs > CDM12Y63 > CDM12Y74 > CDM12Y74M > CDM12Y74T (120mm, 63 minutes) (120mm, 74 minutes) (120mm, 74 minutes) (120mm, 74 minutes) Read-only Discs You can use discs with the logo which conform to the Compact Disc Read Only Memory standard (CD-ROM standard, Yellow Book). If you wish to use the audio functions, use discs with the logo, which conform to the Compact Disc Digital Audio standard (Red Book). 4 Chapter 2 - Installing the Yamaha CRW4260t Drive Chapter 2 - Installing the Yamaha CRW4260t Drive CRW4260t drive settings Before installing the CRW4260t in your computer, you will need to set the following jumpers. You set these jumpers by inserting jumper connectors into the jumper switch located on the rear panel of the CD-RW drive. o o o o SCSI ID settings Parity setting Terminator setting Block size setting Important: Use long-nose pliers to remove or insert jumper connectors. [. . . ] Caution: Be sure to remove the disc after it is completely ejected. (Trying to remove the disc before it is completely ejected may cause the drive to malfunction. ) Press the eject button If the CRW4260t is not powered on: Pressing the eject button will not eject the disc. 15 Chapter 3 - Operation Manual Eject (emergency use) Here we explain how to eject the disc when it cannot be ejected in the normal way; for example, the power is shut off inadvertently or the loading mechanism fails. This technique should be used only as a last resort. You'll need a pin-like object of 2 mm or less in diameter to do this. [. . . ]