User manual YAMAHA CRW8824SX

[. . . ] CRW8824SX SERIES OWNER'S MANUAL BEDIENUNGSANLEITUNG MODE D'EMPLOI MANUAL DE INSTRUCCIONES CD-R/RW Drive FCC INFORMATION COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party: Address: Telephone: Fax: Type of Equipment: Model Name: Yamaha Corporation of America 6600 Orangethorpe Ave. Buena Park, CA 90620 714-522-9011 714-228-3913 CD Recordable/Rewritable Drive CRW8824SX This device complies with Part 15 of the FCC Rules. Operation is subject to the following conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. FCC INFORMATION (U. S. A. ) 1. [. . . ] 22) Headphone jack You can connect stereo headphones to this stereo mini jack and listen to audio CDs loaded in the drive. Headphone volume control Adjust this control to set a suitable volume level when listening to an audio CD using the headphone jack. Slide the knob to the left to decrease the volume and to the right to increase it. ON/DISC LED This LED is orange when the drive is powered on, and green when the drive contains a disc. 30) READ/WRITE LED This LED is green when data is being read off a disc, and orange when data is being written. It flashes on and off intermittently when the disc is being accessed. 30) 8 Front and Rear of Unit Rear Panel The CRW8824SX drive's rear panel features the following: SCSI connectors Connect either of these to your computer's SCSI adapter card using the SCSI cable. The other connector can be used as a pass-through when daisychaining more SCSI devices to it. It can be left vacant if your drive is the last device on the SCSI chain and is terminated. (P. 18) LINE OUT connectors To listen to audio CDs with your drive, connect these to the line-level input (LINE IN) of your stereo equipment using a standard stereo phono cable (sold separately). Power connector Connect the included power cable here. (P. 18) SCSI SCSI CDR ID TERMINATOR OFF ON LINE OUT R L AC IN 1 SER. pppppppp st2 CDR ID selector switch The drive's SCSI ID number is shown in the switch's window. Press the button above the window to decrement the SCSI ID number, or the button below the window to increment it. (P. 10) TERMINATOR switch This enables the drive's built-in SCSI termination. Switch this to "ON" if your drive is the last device on the SCSI chain. Otherwise, switch it to "OFF. " (P. 11) Serial number This consists of 3 letters and 7 digits. You may need to refer to this number when requesting User Support services. 9 Installation This section gives a step-by-step guide to setting up your CRW8824SX drive. First Steps Before connecting your CRW8824SX drive to your computer, you need to set up the drive using the switches located at the rear of the unit. You'll need to set the following: q SCSI ID number q Termination 1 SCSI ID number Each of the SCSI devices connected to the computer is identified by its SCSI ID number. You need to assign a number from "0" to "7" for each SCSI device. Commonly, ID number "7" is reserved for the computer's SCSI adapter card itself. Therefore, your CRW8824SX drive can actually be assigned an ID number from "0" to "6. " Press the top or bottom button of the SCSI ID selector switch to decrement or increment the SCSI ID number, as shown below. Press to decrement SCSI ID number SCSI ID number Press to increment SCSI ID number n The SCSI ID number for each device on the chain must be unique. Make sure the CRW8824SX drive's SCSI ID number is not the same as that of any other device on the chain. By factory default, the CRW8824SX is assigned ID number "1" but this can be changed. n If the SCSI card supports SCAM and SCAM is turned "ON, " a different ID number may be assigned if the SCSI ID number on the rear panel coincides with another SCSI device. 10 Installation 2 Termination Terminators prevent SCSI signals from being reflected off the last device in the chain. [. . . ] 8 High Speed CD-RW disc . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 L lead-in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 lead-out . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 LED Indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]