User manual YAMAHA CS5E

[. . . ] 5 Water and Moisture ­ The unit should not be used near water ­ for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. Carts and Stands ­ The unit should be used only with a cart or stand that is recommended by the manufacturer. 8 Ventilation ­ The unit should be situated so that its location or position does not interfere with its proper ventilation. For example, the unit should not be situated on a bed, sofa, rug, or similar surface, that may block the ventilation openings; or placed in a builtin installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. [. . . ] Operations should be made watching information on this unit's display panel or the monitor screen. (If you want to display information on the monitor, turn the power of the monitor on. Press "+" or "­" once or more so that the arrow points the position you will select. Press once or more until the title of another function on which you will change the selection appears on the display. If you will use the remote control unit, set the TIME/LEVEL· sET MENU switch to the SET MENU position on the remote control unit. NOTE: Be sure to use the remote control unit with the lid open. Press "+" or "­" once or more so that the arrow points the position you will select. Repeat step 4 and 5 to change selections on other functions in the same way. You can make up a multi-room audio/video system with this unit. In this system, this unit and Yamaha audio/video units connected to this unit in the main room can be controlled by using the provided Room 2 remote control unit from the second room so that this unit sends audio and video signals (different from ones selected in the main room) to the amplifier, monitor TV, etc. To use the multi-room functions of this unit, you need the following additional optional products: q An infrared signal receiver for the second room q An infrared emitter in the main room This emitter transmits the infrared signals from the Room 2 remote control unit in the second room to the other components in the main room (for example, CD player or LD player). A TEST hiss-like calibration signal should be heard from the left main speaker, center speaker(s), right main speaker, right rear speaker and left rear speaker in turn (see diagram). Adjust the master VOLUME to a normal listening level. Adjust the level of the speaker selected in step 3 by pressing the + or ­ key so that it becomes almost as same as that of the main speakers. Repeat step 3 and 4 to adjust the level of other speakers. NOTE: If there is insufficient volume from the effect speakers, you may decrease the main speaker volume level by setting the MAIN LEVEL switch on the rear panel to "­10 dB", and adjust each speaker level again. Volume controls on external power amplifiers may also be adjusted if necessary to achieve proper balance. NOTE: If not using a center speaker, be sure to set the "4. cENTER SPEAKER" in the SET MENU mode to the PHNTM (phantom) position. You will then hear the center channel test tone from the left and right main speakers. Adjust the front effect speaker level by pressing the + or ­ key so that it becomes almost as same as that of the main speakers. * While adjusting, the test-tone is fixed on the front effect speaker. [. . . ] The sound is degraded when listening with the headphones connected to the compact disc player or cassette deck that are connected with this unit. The source unit is connected to this unit between digital jacks only. This unit is too close to the affected equipment. WHAT TO DO Unplug the AC power cord from the wall AC outlet, and then plug in again after about one minute. [. . . ]