User manual YAMAHA CS6R VOICE EDITOR

[. . . ] Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Starting Up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Menu Bar . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 The Library Window . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 The Toolbar . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 The Edit Window . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 The Toolbar . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 Voice Edit Window. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15 OMS Settings (Macintosh) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 An Example of Voice Editor in Use . . . . . . . . . . . . . . . . . . 29 Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 · · · · Click on the red-colored text to jump to the related item in this manual. The software and this owner's manual are exclusive copyrights of Yamaha Corporation. Copying of the software or reproduction of this manual in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. Yamaha makes no representations or warranties with regard to the use of the software and documentation and cannot be held responsible for the results of the use of this manual and the software. [. . . ] (If switched on, the LFO waveform is restarted each time you play a note. ) 19 2 LFO PITCH knob Use this to set the pitch modulation depth of the LFO. You can also enter a value directly in the text box to the left of the knob. 3 LFO FILTER knob Use this to set the filter modulation depth of the LFO. You can also enter a value directly in the text box to the left of the knob. 4 LFO AMPLITUDE knob Use this to set the amplitude modulation depth of the LFO. You can also enter a value directly in the text box to the left of the knob. 5 [DETAIL] button Click this to open the "EL DETAIL" dialog and enter the parameters for each Element. You have wider and more accurate control over the parameters than with the editor graphs. 6 Editor graphs Within these graphs, click and drag the square marks (handles) to visually adjust the parameters for each Element. n Sometimes, not all the square marks are visible as they may be layered on top of each other at the same position. In which case, click the visible square mark and drag it away to reveal the next square mark. OSCILLATOR Settings Click on the "WAVE" text box and choose the source waveform. One of the square marks is used to set "VEL LIMIT LOW" and "NOTE LIMIT LOW. " Set the lowest note velocity response by dragging this the square mark horizontally. Set the lowest note in the key range by dragging it vertically. Similarly, set the highest note velocity ("VEL LIMIT HIGH") and key range note ("NOTE LIMIT HIGH") using the other square mark. n When dragging the square marks, values are given as (X, Y) co-ordinates, where X is the NOTE LIMIT (given as a MIDI note number) and Y is the VEL LIMIT. To view the note name instead of the note number, select the "OSCILLATOR" tab of the "EL DETAIL" dialog. FILTER Settings Click on the text box and choose the filter type. The graph shows pre-defined settings initially, but you can edit these. Using the LPF type as an example, drag the left square mark vertically to set the Filter Gain. Drag the right square mark horizontally to set the Filter Cutoff frequency. n Parameter values are shown when dragging the square marks. To set these values directly, select the "FILTER EG" tab of the "EL DETAIL" dialog. 20 EQ Settings Click on the text box and choose the equalizer type. Using the EQ/LH type as an example, the left square mark controls the bass frequencies and the right square mark controls the treble frequencies. Drag the square marks vertically to adjust gain, and horizontally to adjust the frequency. n To set these values directly, select the "OSCILLATOR" tab of the "EL DETAIL" dialog. PITCH EG Settings The PITCH EG (Envelope Generator) determines the transition in pitch while the key is being held down. There are five square marks, each controlling a different stage in the envelope. The first square mark (furthest to the left) controls the "Hold Time/Level. " The second controls the "Attack Time/Level. " The third controls the "Decay 1 Time/Level. " The fourth controls the "Decay 2 Time/Sustain Level. " The last square mark (furthest to the right) controls the "Release Time/Level. " Drag the square marks vertically to adjust levels, and horizontally to adjust the transition times. n To set these values directly, select the "PITCH" tab of the "EL DETAIL" dialog. FILTER EG Settings The FILTER EG (Envelope Generator) determines the transition in timbre while the key is being held down. [. . . ] · Make the correct setting according to the instructions in the CS6x/CS6R/S80/S30 Owner's Manual. · In the OMS Port Setup, is MIDI In/Out set to "unknown"?If you change the OMS ports or setup, the OMS output ports have to be set accordingly in Voice Editor's OMS Port Setup window. Choose the appropriate receiving device. [. . . ]