User manual YAMAHA CVP-209-CVP-207

[. . . ] CVP-209/207 OWNER'S MANUAL OWNER'S MANUAL Introduction SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. Battery Notice: This product MAY contain a small non- rechargable battery which (if applicable) is soldered in place. [. . . ] When this is set to ON, you can use the sostenuto (center) pedal to control the punch-in and punch-out points. Press and hold down the sostenuto pedal to record. Recording stops when you release the pedal. Determines the Punch Out measure -- the measure at which Punch In overwrite recording stops (when "PUNCH OUT AT" is selected). J 1 2 3 4 5 6 7 8 These settings determine how recording will stop as well as what happens to previously recorded data. Replace All This deletes all data following the point at which recording is stopped. Punch Out At Overwrite recording continues until the indicated Punch Out measure (set by the [6LM] buttons), then stops at that Punch Out measure, after which song playback continues normally. Punch Out This maintains all data following the point at which recording is stopped. When the Pedal Punch In/ Out function is set to ON, the current function assignment of the sostenuto pedal is cancelled. About Punch In/Out This feature is useful primarily for re-recording or replacing a specific section of an already recorded channel. The illustrations below indicate a variety of situations in which selected measures in an eight-measure phrase are re-recorded. REC START setting REC END setting NORMAL REPLACE ALL NORMAL PUNCH OUT NORMAL PUNCH OUT AT=006 FIRST KEY ON REPLACE ALL FIRST KEY ON PUNCH OUT FIRST KEY ON PUNCH OUT AT=006 PUNCH IN AT=003 REPLACE ALL PUNCH IN AT=003 PUNCH OUT PUNCH IN AT=003 PUNCH OUT AT=006 Original data 1 Start/start overwrite recording *1 2 3 4 5 6 7 8 Stop recording *2 *1 When measures 1 - 2 are not overwritten, recording starts from measure 3. *2 You'll have to press the [REC] button at the end of 5 measures. 1 Start/start overwrite recording *1 2 3 4 5 Stop recording *2 Deleted 1 Start/start overwrite recording *1 2 3 4 5 6 7 8 Stop overwrite recording/ play original data 1 Start/ play back original data 2 3 4 5 6 7 8 Start playing the keys/ start overwrite recording Stop recording *2 1 Start/ play back original data 2 3 4 5 Stop recording *2 Deleted Start playing the keys/ start overwrite recording 1 Start/ play back original data 2 3 4 5 6 7 8 Start playing the keys/ start overwrite recording Stop overwrite recording/ play original data 1 Start/ play back original data 2 3 4 5 6 7 8 Start overwrite recording Stop recording *2 1 Start/ play back original data 2 3 4 5 Stop recording *2 Deleted Start overwrite recording 1 Start/ play back original data 2 3 4 5 6 7 8 Previously recorded data Newly recorded data Deleted data Start overwrite recording Stop overwrite recording/ play original data 1 2 3 4 5 7 CVP-209/207 103 Recording Your Performances and Creating Songs-- Song Creator Editing a Recorded Song Whether you've recorded a song using Quick Recording, Multi Recording, or Step Recording, you can use the editing features to change the song data. Editing Channel-related Parameters -- Channel Calling up the operations here apply to step 4 on page 98. To call up the display shown below, use the [BACK]/[NEXT] buttons. Quantize Quantize lets you "clean up" or tighten the timing of a previously recorded channel. For example, the following musical passage has been written with exact quarter-note and eighth-note values. Even though you think you may have recorded the passage accurately, your actual performance may be slightly ahead of or behind the beat. Quantize allows you to align all the notes in a channel so that the timing is absolutely accurate to the specified note value (see below). Use this to select the desired edit operation. A F B G C H Executes the Quantize operation. After the operation is completed, this button changes to [UNDO], letting you restore the original data if you're not satisfied with the Quantize results. The Undo function only has one level; only the previous operation can be undone. D I Calls up the SONG display, from which you can save the edited data. Determines how strongly the notes will be quantized. If a value less than 100% is selected, notes will be moved toward the specified quantization beats only by the specified amount. Applying less than 100% quantization lets you preserve some of the "human" feel in the recording. E J 1 2 3 4 5 6 7 8 Selects the desired channel to be quantized. Selects the quantize size (resolution). See the below for the details. I About Quantize Size Set the Quantize size to correspond to the smallest notes in the channel you are working with. For example, if the data was recorded with both quarter notes and eighth notes, use 1/8 note for the Quantize size. If you apply a 1/4 note Quantize size, the eighth notes would be moved on top of the quarter notes. One measure of eighth notes before quantization After 1/8 note quantization Quantize Size 1/4 note 1/8 note 1/16 note 1/32 note 1/16 note + 1/8 note triplet * 1/16 note + 1/16 note triplet * 1/4 note triplet 1/8 note triplet 1/16 note triplet 1/8 note + 1/8 note triplet * The three Quantize settings marked with asterisks (*) are exceptionally convenient, since they allow you to quantize two different note values at the same time, without compromising the quantization of either one. For example, if you have both straight 1/8 notes and 1/8 note triplets recorded to the same channel, and you quantize to straight 1/8 notes, all notes in the channel are quantized to straight 1/8 notes -- completely eliminating any triplet feel in the rhythm. However, if you use the 1/8 note + 1/8 note triplet setting, both the straight and triplet notes will be quantized correctly. 104 CVP-209/207 Recording Your Performances and Creating Songs-- Song Creator Delete This lets you delete recorded data in the specified channel. Use these to select the desired edit operation. A F B G C H Deletes all data in the selected channel. After the operation is completed, this button changes to [UNDO], letting you restore the original data. [. . . ] Lot 8, Jalan Perbandaran, 47301 Kelana Jaya, Petaling Jaya, Selangor, Malaysia Tel: 3-703-0900 SWEDEN Yamaha Scandinavia AB J. Wettergrens Gata 1 Box 30053 S-400 43 Göteborg, Sweden Tel: 031 89 34 00 BRAZIL Yamaha Musical do Brasil LTDA. Rebouças 2636, São Paulo, Brasil Tel: 011-853-1377 PHILIPPINES Yupangco Music Corporation 339 Gil J. Box 885 MCPO, Makati, Metro Manila, Philippines Tel: 819-7551 ARGENTINA Yamaha de Panamá S. A. [. . . ]