User manual YAMAHA CVP-79A-CVP-69-CVP-69A-CVP-59S

[. . . ] IMPORTANT Check Your Power Supply Make sure that your local AC mains voltage matches the voltage specified on the name plate on the bottom panel. In some areas a voltage selector may be provided on the bottom panel of the main keyboard unit near the power cord. Make sure that the voltage selector is set for the voltage in your area. The voltage selector is set at 240V when the unit is initially shipped. [. . . ] "Transposing" the pitch of the Clavinova keyboard makes it easier to play in difficult key signatures, and you can simply match the pitch of the keyboard to the range of a singer or other instrumentalist. Use the data dial or [+]/[­] buttons to set the desired degree of transposition. · Press the [­] and [+] buttons simultaneously to restore normal keyboard pitch ("0"). · The Transpose setting is retained in memory even when the power is turned off if the BACKUP page VOICE SETTING parameter is turned on (page 107), otherwise the Transpose is always set to "0" when the power is turned on. · The transpose function does not affect the Drum Kit voices. · Notes below and above the original 88-key range of the Clavinova sound one octave higher and lower, respectively. s Octave Shift . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . This function includes three parameters which determine whether the left-hand voice in a split keyboard setup (LEFT), the 2nd voice in the dual mode (2ND), and the right-hand or main voice (RIGHT/ 1) will be shifted up or down one octave. Press the LEFT, 2ND, or RIGHT/1 LCD button as many times as necessary to set as required: ­1 0 +1 Corresponding voice shifted down one octave. (Default for the RIGHT/1 and 2nd voices. ) Corresponding voice shifted up one octave. (Default for the LEFT voice. ) · The Octave Shift setting is retained in memory even when the power is turned off if the BACKUP page VOICE SETTING parameter is turned on (page 107). · Notes below and above the original 88-key range of the Clavinova sound one octave higher and lower, respectively. single voice mode) only the RIGHT/1 setting is effective. s Touch Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The Clavinova can be set to one of five different types of keyboard touch sensitivity to match different playing styles and preferences. Press the KEY TOUCH button as many times as necessary to select the desired touch response setting. SOFT 2 SOFT 1 Allows maximum loudness to be produced with very light key pressure. Not as sensitive as the "SOFT 2" setting, but maximum loudness can still be easily produced with relatively light key pressure. Produces a fairly "standard" keyboard response. (Default. ) Requires the keys to be played quite hard to produce maximum loudness. Requires the keys to be played very hard to produce maximum loudness. · The Touch Sensitivity setting is retained in memory even when the power is turned off if the BACKUP page VOICE SETTING parameter is turned on (page 107), otherwise the NORMAL setting is automatically selected whenever the POWER switch is turned on. NORMAL HARD 1 HARD 2 91 Sound s Tune . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The Tune function makes it possible to tune the Clavinova over about a ±26-Hertz (±100-cent) range in 0. 2-Hertz intervals. A hundred "cents" equals one semitone, so the tuning range provided allows fine tuning of overall pitch over a range of approximately a semitone. This function is useful for tuning the Clavinova to match other instruments or recorded music. Use the TUNE v and w LCD buttons to set the tuning as required. The data dial and [+]/[­] buttons can also be used once the TUNE parameter has been selected. The default value of 440. 0Hz can be instantly recalled by pressing the TUNE v and w LCD buttons simultaneously. · The Tune setting is retained in memory even when the power is turned off if the BACKUP page TUNE/MICRO TUNING parameter is turned on (page 107), otherwise the tuning is always set at 440. 0Hz when the power is turned on. · The Tune function does not affect the Drum Kit voices. s Pan . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The pan positions of the left-hand voice in a split keyboard setup (LEFT), the 2nd voice in the dual mode (2ND), and the right-hand or main voice (RIGHT/1) can be individually set via the appropriate PAN parameters. Press the LEFT, 2ND, or RIGHT/1 LCD button according to the voice you want to pan, then use the data dial or [+]/[­] buttons to set the pan position as required. [. . . ] If you are unable to insert the plug into the outlet, turn the plug over and try again. If the problem persists, contact an electrician to have the obsolete outlet replaced. Do NOT defeat the safety purpose of the plug. 3. Care should be taken that objects do not fall and liquids are not spilled into the enclosure through any openings that may exist. 11. 12. Some electronic products utilize external power supplies or adapters. [. . . ]