User manual YAMAHA CVP-49E

[. . . ] SPECIAL MESSAGE SECTION PRODUCT SAFETY MARKINGS: Yamaha electronic products may have either labels similar to the graphics shown below or molded/stamped facsimiles of these graphics on the enclosure. The explanation of these graphics appears on this page. Please observe all cautions indicated on this page and those indicated in the safety instruction section. ENVIRONMENTAL ISSUES: Yamaha strives to produce products that are both user safe and environmentally friendly. [. . . ] q Volume Control The RHYTHM, BASS, CHORD 1, and CHORD 2 volume controls can be used to adjust the volume of the corresponding accompaniment parts when playng back data that was recorded with ABC. When playing back data that was recorded without ABC, however, these volume controls have the following track assignments. RHYTHM: BASS: CHORD 1: CHORD 2: RHYTHM track No assignment No assignment 1 & 2 tracks 28 Performance Memory The Chord Sequence Function The CHORD SEQUENCE function provides a convenient way to enter chord sequences and style changes one at a time. ZEngage the Chord Sequence Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CHORD SEQUENCE Press the [CHORD SEQUENCE] button. The red [ABC] and [RHYTHM] track button indicators will light, and the ABC FINGERED mode will be automatically selected -- switch to the SINGLE FINGER mode if you prefer. If the SINGLE FINGER mode was already selected it will remain engaged. NOTES · The chord sequence data will replace any previous ABC data. · Up to 200 measures can be recorded using the Chord Sequence function. XEnter the Chords and/or Style Changes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . q ?w F 6 G6 BEAT Make the required style changes (style number, normal/variation, fill-in, intro/ ending, and tempo, as necessary), play and hold a chord on the left-hand section of the keyboard, and press the [q] key (look for the "q" symbol above the F6 key) or the [w] key (G6) to enter the chord for a quarter note or whole note, respectively. You can move one beat backward by pressing the [?] key (F#6). Continue entering chords in this manner until your sequence is complete. NOTES Beat Measure number · The number of the measure to be entered is shown on the TEMPO display, while the beat to be entered is shown on the BEAT display. · If no chords are entered, the result will be a rhythm-only sequence. CStop Recording . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . CHORD SEQUENCE When all the required chords and style changes have been entered, press the [CHORD SEQUENCE] button to stop recording. NOTES · The chord sequence data now resides in Performance Memory ABC and RHYTHM tracks, and can be played back in the normal way. Add melody tracks 1 and 2 as required. Utility Mode POP 1 POP 2 29 ZSelect a Utility Function . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Use the [POP 1/POP 2] and [SWING/JAZZ BALLAD] style selectors while holding the [MIDI/TRANSPOSE] button. The [POP 1/POP 2] style selector increments the utility function number each time it is pressed, and the [SWING/ JAZZ BALLAD] button decrements the utility function number. The Utility Mode functions are indicated on the TEMPO display by a tall "U" in the leftmost digit position. The number of the function is displayed by the center digit ("1" or "2"), and the current setting is shown by the right digit. The [MIDI/TRANSPOSE] button must be held until after you've set the function, below. NOTES MIDI/ TRANSPOSE SWING JAZZ BALLAD Utility Mode Setting Function number · You can cancel the selected function at this point and exit from the utility mode simply be releasing the [MIDI/TRANSPOSE] button. XSet as Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MIDI/ TRANSPOSE TEMPO Use the TEMPO [v] and [w] buttons while still holding the [MIDI/TRANSPOSE] button to select the required setting (the available settings for each utility function are listed below). CRelease the [MIDI/TRANSPOSE] Button to Exit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Release the [MIDI/TRANSPOSE] button to exit from the Utility Mode when you've finished making the required settings. U1: Touch Sensitivity The Clavinova can be set to one of three different types of keyboard touch sensitivity to match different playing styles and preferences. 1: Soft. Allows maximum loudness to be produced with relatively light key pressure. Produces a fairly "standard" keyboard response. Requires the keys to be played quite hard to produce maximum loudness. NOTES · The MEDIUM setting (2) is automatically selected whenever the POWER switch is turned on. U2: Accompaniment Volume Mode Normally the Auto Accompaniment volume controls are used to adjust the volume of the Rhythm, Chord 1, Chord 2, and Bass accompaniment parts, as labelled on the Clavinova panel. This function can be used to assign these volume controls to other operations. 1: Volume for the Rhythm, Chord 1, Chord 2, and Bass tracks. This applies when playing with the ABC mode engaged or when playing back performance memory data that was recorded with ABC. When playing back performance memory data that was recorded without ABC, the Chord 2 control corresponds to tracks 1 and 2, the Chord 1 and Bass controls are not assigned. 2: Reverb depth for the Rhythm, Chord 1, Chord 2, and Bass tracks. This applies when playing with the ABC mode engaged or when playing back performance memory data that was recorded with ABC. When playing back performance memory data that was recorded without ABC, the Chord 2 control corresponds to tracks 1 and 2, the Chord 1 and Bass controls are not assigned. NOTES · The Rhythm, Chord 1, Chord 2, and Bass volume setting (1) is automatically selected whenever the POWER switch is turned on. · 1 can be recorded and their initial values can be changed as described on page 26. [. . . ] If you are unable to insert the plug into the outlet, turn the plug over and try again. If the problem persists, contact an electrician to have the obsolete outlet replaced. Do NOT defeat the safety purpose of the plug. 3. Care should be taken that objects do not fall and liquids are not spilled into the enclosure through any openings that may exist. 11. 12. Some electronic products utilize external power supplies or adapters. [. . . ]