User manual YAMAHA CX5ME

[. . . ] Long-term use and vibrations may cause them to pull free. · To avoid accidents resulting from tripping over loose speaker cables, fix these to the wall along with the speaker. Read this before using the speaker. · To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. [. . . ] Keep it in a safe place for future reference. · Install the speaker in a cool, dry, clean place ­ away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of humming (transformers, motors). To prevent fire or electrical shock, do not expose the speaker to rain or water. · To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. · Do not place the following objects on the speaker: Glass, china, etc. falls by vibrations and breaks, it may cause personal injury. ­ If the candle falls by vibrations, it may cause fire and personal injury. A vessel with water in it ­ If the vessel falls by vibrations and water spills, it may cause damage to the speaker, and/or you may get an electric shock. · Do not place the speaker where foreign objects such as water drips might fall. Yamaha shall not be liable for any accident caused by improper placement or installation of the speaker. REMOVING THE SPEAKER GRILLE 1. Remove the side of the fabric speaker grille. 2. Put your hands inside from the sides of the fabric speaker grille and remove the fabric front speaker grille by pushing up the other side. CONNECTING TO YOUR AMPLIFIER Caution BEFORE MAKING CONNECTIONS, MAKE SURE THAT THE AMPLIFIER IS SWITCHED OFF. How to connect the speaker cables When connecting the speaker cable CX5ME/ KMS-2500 (R) CX5ME/ KMS-2500 (L) 1 10 mm Notes · Do not let the bare speaker wires touch each other as this could damage the speaker or the amplifier. · Make sure you connect the speakers with the correct polarity--positive (+) terminals to positive (+) terminals, and negative (-) terminals to negative (-) terminals. If you get them crossed over, the sound will be unnatural and lack bass. · Refer to the owner's manual that came with your amplifier. When using a banana plug Banana plug 3. Remove the 4 screws that hold the metal speaker grille. 4. Remove the metal speaker grille. 4 2 Loosen Tighten Rear panel 3 1. [. . . ] Remove the 4 screws that hold the metal speaker grille. 4. Remove the metal speaker grille. 4 2 Loosen Tighten Rear panel 3 1. 5. Remove 10 mm (3/8") of insulation, and twist the conductors. Test the firmness of the connection by pulling lightly. [. . . ]