User manual YAMAHA DCP4V4S-US/DCP4V4S-EU

[. . . ] If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Electronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620 The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries. To accessories and/or another product use only high quality shielded cables. Failure to follow instructions could void your FCC authorization to use this product in the USA. [. . . ] Before moving the device , remove all connected cables. Always consult qualified Yamaha service personnel if the device installation requires construction work, and make sure to observe the following precautions. - Avoid locations that are exposed to constant vibration. - Use the required tools to install the device. ) into any gaps or openings on the device. If this happens, have the device inspected by qualified Yamaha service personnel. Do not rest your weight on the device or place heavy objects on it, and avoid use excessive force on the buttons, switches or connectors. Yamaha cannot be held responsible for damage caused by improper use or modifications to the device, or data that is lost or destroyed. [DCP] (RJ-45) RJ-45 RJ-45 RJ-45 RJ-45 RJ-45 Error Messages LED Status Meaning Cannot start up properly because of some problem with the hardware. Voltage supply is insufficient due to low power supply voltage from the MTX. A malfunction has occurred with the communication with the MTX. Use CAT5e or higher Ethernet straight cable that has all eight pins connected. Also make sure to connect so that the total length of cables between the MTX and the terminated control panel is no longer than 200 meters. Make sure that each control Panel connected to the same MTX has a unique Panel ID. Make sure that the termination switch is set to ON to terminate the last control panel in a daisy chain connection. The cables may have been broken or there is some other cable connection failure. Information for Users on Collection and Disposal of Old Equipment This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC. By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. ???????????????? [For business users in the European Union] If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. ???????? [Information on Disposal in other Countries outside the European Union] This symbol is only valid in the European Union. [. . . ] Tighten the screws with a torque of less than 1. Also, make sure that the screw heads extend from the control panel by no more than 3 millimeters. dCP4V4S-EU q w Wall box (UK-type) Control panel ????????: ?????????????????????? ????????????????????????? q w ???? 0570-050-808 ?????????????????????????? [. . . ]