User manual YAMAHA DD-65-YDD-60

[. . . ] Digital Percussion Owner's Manual EN SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. This product should be used only with the components supplied or; a cart, rack, or stand that is recommended by Yamaha. If a cart, etc. , is used, please observe all safety markings and instructions that accompany the accessory product. [. . . ] 6 7 8 9 10 Reverb Type Stage 1 Stage 2 Plate 1 Plate 2 Off 3 Press the [FUNCTION] button to exit from the Function mode. DD-65/YDD-60 Owner's Manual 17 Play the Pads/Pedals Setting the Pad Sensitivity The instrument allows you to custom-set the sensitivity of the pads (range 0­2). When set to a value of 2, the pad sensitivity is the highest, providing the most dynamic range for your playing (softest to loudest volume). 1 Enter the Pad Sensitivity setting function. Press the [FUNCTION] button once, then press the [DRUM 1] or [DRUM 2] button a number of times until the "SGL" item appears. After a while, the current Sensitivity value appears next to the "SGL" indication. SnS 2 Set the Sensitivity. To raise the value, turn the DIAL to the right (clockwise), and to lower it, turn the DIAL to the left (counter-clockwise). NOTE · Default value is 1. 0 1 2 3 Exit from the Function mode by pressing the [FUNCTION] button. About the Pad Sound Mechanism Each time you strike a pad, the sensor which is located at the bottom of the pad triggers an electronic signal and makes a drum sound. If you strike a pad too strongly, nearby sensors may also respond to the hit and trigger unwanted sounds. The DD-65/ YDD-60 is set to ignore weak signals from the pads in order to prevent inadvertent, unwanted sounds. However, this may result in problems when intentionally striking two pads simultaneously. If one pad is struck strongly and the other weakly, the pad struck weakly may not sound (even though you want it to). To solve this, you can change the DD-65/YDD-60 settings or alter your playing technique (as described below). Striking two pads simultaneously results in one of the pads not sounding. This may solve the problem if you strike one of the pads weakly. Better yet, take care to strike both pads with equal force. Striking one pad results in other pads also sounding, even though they were not struck. With this setting, pads that are not struck are effectively kept from responding to strong hits on nearby pads. 18 DD-65/YDD-60 Owner's Manual Play the Pads/Pedals Setting the Click ON/OFF The instrument includes a click sound with adjustable tempo and time signature. Press the [CLICK] button. The click sounds in rhythm at the current tempo. (See "Adjusting the Tempo" on page 25. ) To turn the click off, press the button once again. Setting the Time Signature of the Click Setting the numerator of the time signature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The range is 0 to 16. The first beat is accented with a bell sound and the rest with clicks. 1 Enter the numerator value setting function. Press the [FUNCTION] button once, then press the [DRUM 1] or [DRUM 2] button a number of times until the "CL1" item appears. After a while, the current numerator value appears next to the "CL1" indication. CL1 2 Set the numerator value of the time signature. To raise the value, turn the DIAL to the right (clockwise), and to lower it, turn the DIAL to the left (counter-clockwise). NOTE · Default value is 4. · When set to 00, the click sounds all beats with a click sound (no accent). 0 1 15 16 3 Press the [FUNCTION] button to exit from the Function mode. DD-65/YDD-60 Owner's Manual 19 Play the Pads/Pedals Setting the denominator of the time signature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Set the basic note value for each measure. 1 Enter the denominator value setting function. Press the [FUNCTION] button once, then press the [DRUM 1] or [DRUM 2] button a number of times until the "CL2" item appears. After a while, the current denominator value appears next to the "CL2" indication. CL2 2 Set the denominator value of the time signature. Set the denominator value to one of the values 2 ( ), 4 ( ), 8 ( ), 16 ( ) by using the DIAL. NOTE · Default value is 4. 2 4 8 16 3 Press the [FUNCTION] button to exit from the Function mode. Setting the click volume . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Sets the click volume (range: 1­127). 1 Enter the click volume setting function. Press the [FUNCTION] button once, then press the [DRUM 1] or [DRUM 2] button a number of times until the "CL3" item appears. After a while current click volume will appear next to the "CL3" indication. CL3 2 Set the click volume by using the dial. 1 2 126 127 3 Press the [FUNCTION] button to exit from the Function mode. 20 DD-65/YDD-60 Owner's Manual Play the Pads/Pedals Setting Equalization On/Off When you use the internal speakers, set Equalization to ON (default setting is on). When you use headphones or external speakers, set this to off. 1 Enter the Equalization setting function. Press the [FUNCTION] button once, then press the [DRUM 1] or [DRUM 2] button a number of times until the "Eq" item appears. After a while, the current On/Off setting will appear next to the "Eq" indication. Eq 2 Set the Equalizer On/Off. Turn the DIAL clockwise to set to ON, and turn it counter-clockwise to set it to OFF. OFF On 3 Press the [FUNCTION] button to exit from the Function mode. DD-65/YDD-60 Owner's Manual 21 Playing a Song This instrument features 100 different songs (five demo songs, as well as Rhythm patterns and Fill-in patterns) that can be used to provide accompaniment. [. . . ] Nusantik Gedung Yamaha Music Center, Jalan Jend. 4, Jakarta 12930, Indonesia Tel: 21-520-2577 CENTRAL & SOUTH AMERICA MEXICO Yamaha de México S. A. 09300, México, D. F. , México Tel: 55-5804-0600 SPAIN/PORTUGAL Yamaha-Hazen Música, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 KOREA Yamaha Music Korea Ltd. [. . . ]