User manual YAMAHA DISKLAVIER CONTROLLER

[. . . ] Compatible devices (as of September 1, 2010) This application is compatible with the following Apple products (iOS 3. 0 or later is required). · iPhone · iPod touch · iPad Requirements · The firmware of your Disklavier must be Version 4. 00 or later for Mark IV, or Version 3. 00 or later for E3. Refer to the Disklavier operating manual and update the firmware. [. . . ] [ ] (skip back / rewind) Skips to the previous song when tapped briefly (less than one second). Rewinds through the current song when tapped for a longer period (at least one second). * Operations in this application may not always take effect on your Disklavier immediately. Chapter 2 Song Playback 13 Operation during Playback (continued) Tap on the screen during playback. Repeat mode Cycles through the repeat mode. : Repeat off : Single repeat mode : All repeat mode : Random repeat mode Main volume Adjusts the main volume. Quiet status*1 Cycles through the quiet status. : Acoustic mode : Quiet mode : Headphone mode*2 *1 You cannot change quiet status when connected to some models of the Disklavier E3. *2 For Disklavier E3 upright pianos, this does not appear. For Disklavier E3 grand pianos and Disklavier Mark IV, the quiet status is locked to Headphone mode when you connect headphones. Chapter 2 Song Playback 14 3 DisklavierRadio Playback Introduction 15 Selecting a Channel Tap on [Select] in the toolbar. Tap on [DisklavierRadio] or [D-Radio]. [Disklavier Radio] [D-Radio] Next, select a channel. Selecting a channel (page 17) Chapter 3 DisklavierRadio Playback 16 Selecting a Channel (continued) Tap on the desired channel. [Source] Returns to source selection. Channel list* * To select channels other than the two complimentary channels, you must first log into the Internet Direct Connection (IDC) service on the Disklavier. [Media] Returns to media selection. Channel list* * To select channels other than the two complimentary channels, you must first log into the Internet Direct Connection (IDC) service on the Disklavier. The selected channel is played back. Operation during playback (page 18) Chapter 3 DisklavierRadio Playback 17 Operation during DisklavierRadio Playback Tapping on the screen during DisklavierRadio playback shows the song control panel for various operations. *1 Display of the song control panel cycles on and off every time you tap on the screen. Tap on the screen during playback. Channel title / song title [Mute Off] / [Mute On] Cycles the mute function on and off. Quiet status*2 Cycles through the quiet status. : Acoustic mode : Quiet mode : Headphone mode*3 *1 Operations in this application may not always take effect on your Disklavier immediately. *2 You cannot change quiet status when connected to some models of the Disklavier E3. [. . . ] Refer to the Advanced Operating Manual for more information. For Disklavier E3 users: You can access this screen by pressing [SETUP] on the remote control, then selecting "Passcode. " Refer to the Operation Manual for more information. Set the 4-digit number as the passcode. You can control your Disklavier with the Disklavier Controller by entering the passcode set in this screen (see page 6). [. . . ]