User manual YAMAHA DMP7D

[. . . ] The PATCH LINK INPUT and OUTPUT parameters can be found on the Scene Memory page shown below, which is located by pressing the SCENE MEMORY [DISPLAY] button. 3-1 ON 3-1 OFF ST ON ST OFF Use the cursor buttons to select the PATCH LINK INPUT and OUTPUT parameters, use the Parameter wheel to select Input Patch and Output Patch library memories, and press the [ENTER] button to set. [. . . ] A dash (­) means that no patch memory is selected. When you store a Scene, the last recalled or stored Input Patch and Output Patch library memories are automatically linked to that Scene. If the specified Input or Output Patch library memory contains no data, only the Scene is recalled, the input and output patching will remain the same. Note: When using the 3-1 monitor matrix, even with film sources, use Bass Management presets 1 and 2 (presets 3 and 4 may not provide correct monitoring). In addition, the Monitor Matrix configurations have changed as follows. When the DAW CONTROL option is on, the DAW can be controlled regardless of which Layer is currently selected. 2 Dimmer & Talkback Control via the CONTROL Port The Control Room and Surround Monitor Dimmers, and the Talkback function can now be controlled remotely via the CONTROL port. User Defined Keys The following items have been added to the list of functions that can be assigned to the USER DEFINED KEYS. # 161 162 163 Function Surr Lib. XX Display Surr Lib+1 RCL Surr Lib­1 RCL Surr LibXX RCL Each time the GPI0 input (pin 22) goes Low (ground), Talkback is turned on or off. Each time the GPI1 input (pin 10) goes Low (ground), the Dimmer is turned on or off. Solo to Studio Out With the new Solo Bus to Studio Out preference on the Preferences 1 page, which can be selected by using the DISPLAY ACCESS [SETUP] button, soloed channels can now be monitored through the STUDIO MONITOR OUT. Functions are assigned to the USER DEFINED KEYS on the USER DEFINED KEY ASSIGN page, which is selected by using the USER DEFINED KEYS [DISPLAY] button. In addition, the following initial assignments of USER DEFINED KEYS Bank A have changed. # 1 2 3 Bank A SOLO ON No Assign No Assign --> --> --> # 1 2 3 Bank A Surr Lib 0 RCL Surr Lib ­1 RCL Surr Lib +1 RCL When the Solo Bus to Studio Out preference is on, and all the STUDIO signal source buttons in the MONITOR section are off (i. e. , [CONTROL ROOM], [STEREO], [AUX 11], and [AUX 12]), the Solo signal is output by the STUDIO MONITOR OUT when channels are soloed. 3 M. D. G. , PA·DMI Division, Yamaha Corporation © 2002 Yamaha Corporation [. . . ] Each time the GPI1 input (pin 10) goes Low (ground), the Dimmer is turned on or off. Solo to Studio Out With the new Solo Bus to Studio Out preference on the Preferences 1 page, which can be selected by using the DISPLAY ACCESS [SETUP] button, soloed channels can now be monitored through the STUDIO MONITOR OUT. Functions are assigned to the USER DEFINED KEYS on the USER DEFINED KEY ASSIGN page, which is selected by using the USER DEFINED KEYS [DISPLAY] button. [. . . ]