User manual YAMAHA DSR-2000-DSR-1000

[. . . ] 4 X-Over Input Level (Speaker Processor) . . . . . . . . . . . . . . 35 X-Over Polarity (Speaker Processor). . . . . . . . . . . . . . . . . . . . 35 X-Over (Speaker Processor). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 36 Output Delay (Speaker Processor) . . . . . . . . . . . . . . . . . . . . . . . [. . . ] (They are fixed at PEQ. ) For details on the filter types, refer to page 38. Specifies the width of each frequency band. Specifies the center frequency of each frequency band. Specifies the gain for each frequency band. Turns bypass on/off for each frequency band. Turns the entire eight-band equalizer on/off. Q Frequency Gain Bypass EQ All Bands Input Delay Here you can specify a delay for the signal. Parameter name On Delay Time Range ON/OFF 0. 00­1, 300. 00 ms Turns the delay on/off. Specifies the delay time. Explanation 34 TX6n/5n/4n Reference Manual Panel Operations Oscillator Mix This is a mono-channel oscillator. It generates a sine wave, pink noise, or burst noise. This can also mix the audio input signal and oscillator signal. Parameter name PGM To SP Osc To SP Osc On Osc Level Wave Form Range ON/OFF ON/OFF ON/OFF - ­0. 00 dB SINE100 Hz, SINE1 kHz, SINE10 kHz, PINK, BURST, Vari 20. 0 Hz­20. 0 kHz Explanation Switches on/off the input from the Input Delay to the mix point before the Speaker Processor. Switches on/off the input from the oscillator to the mix point before the Speaker Processor. Selects the waveform that will be generated. This is used to correct the phase at the crossover band. APF 1st will invert the phase 0°­180° and APF 2nd will invert the phase 0°­360°. For APF 2nd, you can adjust the Q setting. · Horn EQ CD (Constant Directivity) horn speakers have the characteristic of rolling-off the level of the high-frequency range. Horn EQ is an equalizer that compensates for this characteristic. For this reason, the Gain is limited to 0 dB or higher, and the Frequency is limited to 500 Hz or higher. Output Level (Speaker Processor) This adjusts the output level in a range of - ­ +10 dB. Mute On/Off (Speaker Processor) Turns output muting on/off. 38 TX6n/5n/4n Reference Manual Panel Operations Limiter (Speaker Processor) This compresses signals exceeding the threshold at :1, preventing signals higher than the threshold level from being output. Parameter name On Threshold Attack Mode Range ON/OFF -54­0 dB Fast, Mid, Slow, Manual Turns the limiter on/off. Explanation Specifies the threshold value for the limiter. Selects the attack speed of the limiter. If the Manual setting is selected, use the Attack setting below to specify the attack time. If Fast/Mid/Slow is selected, the attack time is specified roughly according to the HPF cutoff frequency of Speaker Processor's Crossover. Fast : 1/4 wavelength of cutoff frequency Mid : 1/2 wavelength of cutoff frequency Slow : 1 wavelength of cutoff frequency Attack Release Mode 0. 0­120. 0 ms Fast, Mid, Slow, Manual Specifies the attack time when Manual mode is selected. Selects the release speed of the limiter. [. . . ] 37 Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 38 Output Router . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 Output Signal Chain. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27 Override . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]