User manual YAMAHA DTX522K/DTX542K ASSEMBLY MANUAL

[. . . ] • Holders for cymbal and tom pads have sharp tips. In order to avoid injury, therefore, you should take special care whenever handling these components. • The anti-slip stoppers on kick pads and foot pedals have sharp tips. [. . . ] Doing so could cause clamps to break and the drums to fall off, which in turn could lead to injury. 1. Remove the drum module clamp a and the left leg b from the left side of the rack. 2. Assemble the holder clamp for the hi-hat holder, ensuring that it is oriented as shown in the figure. Following this, reassemble the left leg b and the drum module clamp a. Hi-hat holder Holder clamp NOTICE: Usage Precautions • When connecting and disconnecting cables, be sure to hold the plug and not the cable itself. In addition, avoid placing heavy items on top of cables and do not allow them to touch sharp edges. Failure to avoid these precautions can lead to cable breakage and disconnection. • Do not climb onto the electronic drum kit and avoid placing heavy objects on it. Failure to observe this precaution can result in malfunction. • Avoid using or storing the electronic drum kit in very hot locations (i. e. , in direct sunlight, in close proximity to a heater, or in a closed vehicle) or in highly humid locations (i. e. , in a bathroom or outdoors in wet weather). Failure to observe this precaution can lead to warping, discoloration, malfunction, or breakdown. • Avoid cleaning the electronic drum kit with organic solvents, paint thinner, or alcohol as these substances can cause warping and discoloration. Instead, we recommend you remove dust using a soft dry cloth or wipe clean using a moist, tightly-wrung cloth. If the electronic drum kit is very dirty, first wipe the dirt away using a cloth moistened with a neutral detergent solution and tightly wrung. Following this, wipe away the detergent solution using a cloth soaked in water and tightly wrung. Drum module clamp a Drum module clamp a Left leg b Left leg b * Yamaha Corporation reserves the right to change or modify products or specifications at any time without prior notice. Continued on rear. Assembling the snare and tom pads Tom pads DTX522K: TP70 DTX542K: XP70 Assembling the kick pad 2. Push the snare pad onto the rack’s snare holder. Ensure that the snare holder’s rod is fully inserted into the snare pad’s mounting hole, and then tighten the clamp bolt to secure the pad in place. Snare pad Snare holder Rod  Tom pads 1. 1. As with the snare pad, attach a wing bolt (DTX522K) or clamp bolt (DTX542K) to each of the three tom pads and provisionally tighten (by five or six turns). [. . . ] Place one of the felt pads removed in Step 2 on the cymbal holder. A cymbal pad’s built-in sensor is located close to the Yamaha logo found on the top surface. In order to achieve the best performance from your pad, position it such that the area around the logo can be easily struck. (See the figure above. ) 7. Bolt cover Mount the pad on the cymbal stand. [. . . ]