User manual YAMAHA DTX-900K ASSEMBLY MANUAL

[. . . ] They may become pinched, resulting in injury. · Be careful around pipe ends, inside the pipe and screw ends. · Do not put your hands or feet under the foot pedal or foot switch. [. . . ] Also, never place any heavy or sharp objects on the cable. Applying excessive force to the cable may result in damage to the cable, such as the wires being severed, etc. · Do not step on or place heavy objects on the product. · Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or high humidity (bathroom, outside on a rainy day, etc. ). Doing so may result in deformation, discoloration, damage or deterioration. · When cleaning the product, do not use benzine, thinner or alcohol as it may result in discoloration or deformation. Please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. If the product is soiled or sticky, use a neutral detergent on a cloth then wipe with a damp cloth that has been wrung out thoroughly to remove any remaining detergent. Also pay close attention so as not to let the water and detergent come into contact with the cushions used in the product; doing so may result in deterioration. 3. If you want to change the location (height and 1. Attach the clamp bolt then tighten it with five or six turns on each of three Tom Pads. Clamp bolt (to be tightened as shown) angle) of the Tom Pad, use the clamp bolts A and B. Loosen the one of the clamp bolts, adjust the location of the Pad, then make sure to tighten the clamp bolts again before adjusting another clamp bolt. Clamp bolt B a Tom pad (back side) Additional Holder Clamp Loosen the screws. * Specifications and descriptions in this owner's manual are for information purposes only. reserves the right to change or modify products or specifications at any time without prior notice. Since specifications, equipment or options may not be the same in every locale, please check with your Yamaha dealer. Clamp bolt A Continued on the next page (on the back side) Attaching the Cymbal Pad Assembling the Kick Pad Assembling the Snare Stand and Snare Pad 2. Attach the stopper to the Cymbal Holder, and fix at PCY155 PCY135 PCY135 5. Insert the end of the L-shaped part of the stopper into the oval-shaped hole (shown as a) on the Cymbal Pad to set the Pad on the Holder. * Cymbal Pad PCY135 is very similar to Real HighHat Pad RHH135. Check the model name on the reverse side. 1. If a drum mat (sold separately) is not available, lay a sheet of cardboard on the floor to prevent scratching the surface. a position where the L-shaped part of the stopper is on the opposite side from you. [. . . ] Loosen the wing bolt (shown with a) of the Hi-Hat Stand. B A Support plate Cymbal support plate 1. Make sure the F (Standby/On) switch is set to the Standby position (?), then connect the AC power adaptor to the DC IN jack on the rear panel. Twist the cable around the cable clip to prevent the DC plug from inadvertently being disconnected. 3. [. . . ]