User manual YAMAHA DTXTREMEE2

[. . . ] SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. Battery Notice: This product MAY contain a small non-rechargeable battery which (if applicable) is soldered in place. The average life span of this type of battery is approximately five years. When replacement becomes necessary, contact a qualified service representative to perform the replacement. [. . . ] If necessary, go back to step 1 and switch to the other insertion effect in order to set it up following steps 2 to 5. n Available edit pages and parameters may vary depending on the effect type you choose. Refer to the Effect Type List in the Appendix for details. 1 FX= Choose the target insertion effect. Settings: FX=1 (insertion effect 1), FX=2 (insertion effect 2) 55 2 Type Choose an effect type to assign. You can assign any of 44 insertion effect types. Settings: THRU, HALL1, HALL2, ROOM1, ROOM2, ROOM3, STAGE1, STAGE2, PLATE, DelayLCR, DelayLR, ECHO, CrossDlay, KARAOKE1, KARAOKE2, KARAOKE3, CHORUS1, CHORUS2, CHORUS3, CHORUS4, CELESTE1, CELESTE2, CELESTE3, CELESTE4, FLANGER1, FLANGER2, FLANGER3, SYMPHONIC, ENSEMBLE, ROTARY, TREMOLO, AUTOPAN, PHASER, DISTORTION, OVERDRIVE, AMPSIM, 3BANDEQ, 2BANDEQ, FILTER, AUTOWAH, TOUCHWAH1, 2, ENHANCER, COMP, NOISEGATE NORMAL 60 degrees 0. 5m Left and right speakers positioned 0. 5 meter ahead of the listener, at the angle of 60 degrees. NEAR Other Edit Pages and Parameters Available edit pages and parameters may vary depending on the effect type (Type) you choose. When you choose an effect type, there will be associated parameters provided in multiple edit pages. n Refer to the Effect Type List in the Appendix for details of available edit pages and parameters. Drum Kit Effect Edit Mode REFERENCE SECTION 60 degrees 0. 3m Left and right speakers positioned 0. 3 meter ahead of the listener, at the angle of 60 degrees. FAR Localizer [Loclizr] HEADPHONE LOCALIZER SETUP1 You can specifically set the Localizer's 3D stereophony in this page when you have enabled it in the [Effect] page (page 54). The Localizer's 3D effects are only effective when monitored through stereo headphones. When monitored through speakers, sounds applied the Localizer effects may be heard strangely. [Loclizr] Type DrSens AcpSens NORNAL 16 16 HRTF 15 2m 60 degrees Left and right speakers positioned 2 meters ahead of the listener, at the angle of 60 degrees. 1 2 3 4 WIDE 1 Type Choose a stereophonic effect from 5 preset types. The following illustrations show how each stereophonic effect (virtual stereo speakers) is monitored using the headphones. 120 degrees 0. 5m Left and right speakers positioned 0. 5 meter ahead of the listener, at the angle of 120 degrees. 56 POINT [Loclizr] HEADPHONE LOCALIZER SETUP2 Continued from the HEADPHONE LOCALIZER SETUP1 page, you can set parameters for the 3D effect monitored with the headphones in this page when you have enabled it in the [Effect] page (page 54). [Loclizr]Rotation Dist 120 10. 0 A speaker positioned 0. 5 meter ahead of the listener. 0. 5m Angle 30 1 2 3 Settings: THRU, NORMAL, NEAR, FAR, WIDE, POINT 2 DrSens (Drum Sense) Specify the stereophonic position of the drum kit. A larger value will accordingly emphasize the 3D positioning. A smaller value will accordingly emphasize the normal stereo panning (as specified in Drum Kit Voice Edit mode). The value "0" bypasses the Localizer and no 3D effect is applied. Settings: 0 - 16 1 Rotation Specify the position (angle) of all instruments available on the DTXTREME. This is a virtual position perceived when monitored with headphones. As a larger positive value is set, all instruments including the drum kit will accordingly rotate clockwise from the listener's front to back (0 to 180 degrees). As a larger negative value is set, all instruments including the drum kit will accordingly rotate counterclockwise from the listener's front to back (0 to 180 degrees). Settings: -180 (back) - 0 (front) - 180 (back) [unit: degree] Drum Kit Effect Edit Mode REFERENCE SECTION 3 AcpSens (Accompaniment Sense) Specify the stereophonic position of accompanying instruments (other than the drum kit). A larger value will accordingly emphasize the 3D positioning. A smaller value will accordingly emphasize the normal stereo panning. The value "0" bypasses the Localizer and no 3D effect is applied. Settings: 0 - 20 2 Dist (Distance) Specify the distance of all instruments available on the DTXTREME. This is a virtual distance perceived when monitored with headphones. As a larger value is set, all instruments including the drum kit will accordingly become further. Settings: 0. 3 - 10. 0 [unit: meter] 4 HRTF (Head Related Transfer Function) Perception of the sound image is different from person to person. An audible effect that one person cannot perceive may give an extreme effect (sound modulation) to another. The HRTF parameter can compensate for such personal differences in perception. Settings: 0 - 20 3 Angle Specify how the sounds from the DTXTREME will play in stereo width (left to right). With the center at zero (0), the sounds will expand to a maximum width of 180 degrees. Settings: 0 (center) - 180 (left to right) [unit: degree] 57 Chain Play Mode A chain is a programmed sequence that arranges multiple drum kits or songs in a certain order. In Chain Play mode, you can choose that chain, and recall and play a drum kit or song. [. . . ] Rebouças 2636, São Paulo, Brasil Tel: 011-853-1377 SWEDEN Yamaha Scandinavia AB J. Wettergrens Gata 1 Box 30053 S-400 43 Göteborg, Sweden Tel: 031 89 34 00 PHILIPPINES Yupangco Music Corporation 339 Gil J. Box 885 MCPO, Makati, Metro Manila, Philippines Tel: 819-7551 ARGENTINA Yamaha Music Argentina S. A. Viamonte 1145 Piso2-B 1053, Buenos Aires, Argentina Tel: 1-371-7021 DENMARK YS Copenhagen Liaison Office Generatorvej 8B DK-2730 Herlev, Denmark Tel: 44 92 49 00 SINGAPORE Yamaha Music Asia Pte. , Ltd. [. . . ]