User manual YAMAHA DX100E

[. . . ] (2 wires) COMPLIANCE INFORMATION STATEMENT (DECLARATION OF CONFORMITY PROCEDURE) Responsible Party : Address : Telephone : Type of Equipment : Model Name : Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. 90620 714-522-9011 USB Mixing Studio MW8CX/DX100E This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received including interference that may cause undesired operation. See user manual instructions if interference to radio reception is suspected. * This applies only to products distributed by YAMAHA CORPORATION OF AMERICA. [. . . ] Other instruments should be evenly balanced throughout the sound stage in a well-balanced manner. 7 8 When the final mix adjustments have been made, go to the [File] menu and select [Export] [Audio Mixdown]. Enter a file name and select a destination for the file as well as a file type. If you intend to use the file to create an audio CD, select the WAV file type (AIFF on Mac OS X), 16 bit, and 44. 1 kHz. 9 Click [Export]. Progress of the mixdown operation will be shown in a progress window. When the progress window closes the mixdown is complete. NOTE 5 At this point you can begin to use EQ to refine your mix, and add effects. As an example let's try adding reverb. Click the [Edit] button ( ) on the left side of the channel strip to open the VST audio channel settings window. Click Inserts 1 and select "Reverb - RoomWorks SE". Audio files created by mixdown can be directly played back using the Windows Media Player, or iTunes on a Mac computer. NOTE For further details refer to the pdf manual provided with the Cubase AI software. It's a good idea to lower the channel fader a bit before adding an effect, since the effect can cause an increase in the overall channel level. CAUTION 14 MW8CX/DX100E Owner's Manual Reference Setup Reference Synthesizer Guitar Powered Speakers Bass CD Player Recorder DI Microphone Effect Processor (exciter) Foot Switch (YAMAHA FC5) Headphones Powered Monitor Speakers Effect Processor Personal Computer MW8CX MW8CX/DX100E Owner's Manual 15 Reference Front & Rear Panels The following applies to both the MW8CX and DX100E. In cases where different features need to be described for each model, the MW8CX feature will be described first, followed by the DX100E feature in brackets: MW8CX (DX100E). Channel Control Section 1 MIC Input Jacks (CHs 1 to 5/6) Channels 1 and 2 (Monaural) Channels 3/4 and 5/6 (Stereo) Channels 7/8 (7/8 and 9/10) (Stereo) These are balanced XLR-type microphone input jacks (1:Ground; 2:Hot; 3:Cold). 2 LINE Input Jacks (CHs 1, 2) These are balanced TRS phone-jack line inputs (T:Hot; R:Cold; S:Ground). You can connect either balanced or unbalanced phone plugs to these jacks. 1 2 1 4 3 LINE Input Jacks (CHs 3/4 to 7/8 (CHs 3/4 to 3 3 9/10)) These are unbalanced phone-jack stereo line inputs. 5 4 LINE Input Jacks (CH 7/8, (CHs 7/8, 9/10)) These are unbalanced stereo RCA pin jacks. NOTE 6 7 8 6 7 Where an input channel provides both a MIC input jack and a LINE input jack, or a LINE input jack and an RCA pin jack, you can use either jack but not both at the same time. Please connect to only one jack on each channel. 5 INSERT Jacks (CHs 1, 2) 9 Each of these jacks provides an insert point between the equalizer and LEVEL control of the corresponding input channel (CHs 1, 2). The INSERT jacks are ideal for connecting devices such as graphic equalizers, compressors, or noise filters into the corresponding channels. These are TRS (tip, ring, sleeve) phone jacks that carry both the send and return signal (tip = send/out; ring = return/in; sleeve = ground). NOTE 9 0 0 0 Patching external devices via an INSERT jack requires a special insert cable such as illustrated below (insert cable sold separately). If you connect to the L (MONO) jack only, the mixer will recognize the signal as monaural and will send the identical signal to both the L and R jacks. 4 SEND EFFECT (AUX) Jack This is an impedance balanced* TRS phone jack that outputs the signal from the EFFECT (AUX) bus. You can use this jack, for example, to connect to an external effect unit. 4 7 5 STEREO OUT (L, R) Jacks These are impedance balanced* TRS phone jacks that output the signals adjusted by the STEREO Master control E. You can use these jacks, for example, to connect to the power amplifier driving your main speakers. 6 MONITOR (L, R) Jacks 0 8 A These are impedance balanced* TRS phone jacks that output the signals adjusted by the MONITOR/PHONES control C. Connect these jacks to your monitor system. 7 PHONES Jack Connect a pair of headphones to this TRS phone jack. The PHONES jack outputs the same signal as the MONITOR OUT jacks. 9 B C D 8 PHANTOM +48 V Switch This switch toggles phantom power on and off. When the switch is on the mixer supplies +48V phantom power to all channels that have XLR mic input jacks (CHs 1­5/6). Turn this switch on when using one or more phantom-powered condenser microphones. NOTE MW8CX When this switch is on the mixer supplies DC +48 V power to pins 2 and 3 of all XLR-type MIC INPUT jacks. · Be sure to leave this switch off ( not need phantom power. ) if you do 1 2TR IN Jacks These RCA pin jacks can be used to input a stereo sound source. Use these jacks when you want to connect a CD player directly to the mixer. NOTE CAUTION Select where you want to send the signal using the 2TR IN/USB switch B, and adjust the signal level using the 2TR IN/USB control in the Master Control section. · When turning the switch on ( ), be sure that only condenser mics are connected to the XLR input jacks (CHs: 1 to 5/6). Devices other than condenser mics may be damaged if connected to the phantom power supply. [. . . ] 2F, Yunhedasha, 1818 Xinzha-lu, Jingan-qu, Shanghai, China Tel: 021-6247-2211 FRANCE Yamaha Musique France BP 70-77312 Marne-la-Vallée Cedex 2, France Tel: 01-64-61-4000 U. S. A. Yamaha Corporation of America 6600 Orangethorpe Ave. , Buena Park, Calif. Tel: 714-522-9011 HONG KONG Tom Lee Music Co. , Ltd. 11/F. , Silvercord Tower 1, 30 Canton Road, Tsimshatsui, Kowloon, Hong Kong Tel: 2737-7688 ITALY Yamaha Musica Italia S. P. A. Combo Division Viale Italia 88, 20020 Lainate (Milano), Italy Tel: 02-935-771 INDIA Yamaha Music India Pvt. [. . . ]