User manual YAMAHA ELS-02/02C

[. . . ] • Bench board • Legs • Foot rest • Bolts • Washers • Screws • Wrench* 1 4 1 4 4 4 1 Foot rest *Wrench is attached on the backside of bench board. 3 Install the two legs for the back side. Have a Phillips-head (+) screwdriver of the appropriate size ready. Bench assembly 1 Turn the bench board over and install two legs for the front side. Tighten the bolts using the included wrench (as shown). CAUTION Make sure to put washers between the bolts and the bench board. [. . . ] Make sure to properly tighten all bolts so that there is no gap between the bolts and the washers. If the bolts are not properly tightened, accident or injury may occur. After completing the assembly, be sure to read the “PRECAUTIONS” section of the Owner’s Manual of ELS-02/ELS-02C. R Washer Bolt L Logo is written on back –1– Post-assembly checklist After completing the assembly, please check the following.  If the bench is unstable, adjust the bench legs, referring to the instructions in the next section, “If the bench is unstable. ” • Are the legs attached correctly (left and right)? R If the bench is unstable If the bench is unstable, adjust it in the following manner. 1 With the legs on the floor in the normal position, temporarily loosen the bolts indicated with a mark written on them. 2 L Tighten the bolts that attach the legs using the included wrench. Make sure to properly tighten all bolts so that there is no gap between the bolts and the washers. Bolt Logo is written on back Washer 3 Return the bench to the original position, and check that the bench is stable. If the bench is in any way unstable, adjust it in steps 1 and 2 again. If this does not solve the problem, contact your Yamaha dealer. If the bench bolts/screws become loose due to extensive long-term use, tighten them periodically using the included tool and a screwdriver. EN C. S. G. , DMI Development Division © 2014 Yamaha Corporation Published 04/2014 MW-01B0 –2– ZJ88110 [. . . ]  If the bench is unstable, adjust the bench legs, referring to the instructions in the next section, “If the bench is unstable. ” • Are the legs attached correctly (left and right)? R If the bench is unstable If the bench is unstable, adjust it in the following manner. 1 With the legs on the floor in the normal position, temporarily loosen the bolts indicated with a mark written on them. 2 L Tighten the bolts that attach the legs using the included wrench. Make sure to properly tighten all bolts so that there is no gap between the bolts and the washers. Bolt Logo is written on back Washer 3 Return the bench to the original position, and check that the bench is stable. If the bench is in any way unstable, adjust it in steps 1 and 2 again. [. . . ]