User manual YAMAHA EXI8/EXO8

[. . . ] ователя 取扱説明書 EN DE FR ES IT RU ZH JA 日本語 中文 Русский Italiano Español Français Deutsch English Explanation of Graphical Symbols CAUT I ON RISK OF ELECTRIC SHOCK DO NOT OPEN The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. The above warning is located on the top of the unit. install in accordance with the manufacturer’s instructions. [. . . ] Alert number Example: When a problem related to alert number “3” occurs t [POWER] indicator This indicator will light when this device is powered-on. Y [NETWORK] indicator This indicator will light green if a link is established with an external device via the rear panel NETWORK connector (page 9). It will flash while data is being sent or received. eXi8/EXo8 Owner’s Manual 7 Controls and Connectors Rear Panel i q w e ON r t y u * Illustration shows EXi8. NOTE The EXi8/EXo8 has some connectors that are shaped identically but have a completely different function (e. Make the appropriate connections as instructed by the explanation for each connector. Otherwise, you risk damaging your equipment. R DIP switches These switches enable you to specify the settings related to the startup operation of the EXi8/EXo8. NOTE Set the DIP switches while the power to the unit is turned OFF. Otherwise, the setting will not be effective. Q Ground screw The supplied power cord has a three-prong plug that will ground the device when plugged into an appropriately grounded three-prong type AC mains outlet. In some cases, you may be able to reduce hum or interference by also connecting this screw to ground. W AC IN connector Use the included power cord to supply power to this connector. First, connect the power cord to this device, and then insert the power cord plug into the AC outlet. ρ Switches 1–2 (UNIT ID) These switches specify the upper digit and the abovementioned [UNIT ID] rotary switch specifies the lower digit, together allowing you to specify one of 63 different UNIT ID numbers in a range from 01 to 3F. Switch position Option UNIT ID is “0x” UNIT ID is “1x” UNIT ID is “2x” UNIT ID is “3x” Functions The [UNIT ID] rotary switch will have a setting range of 01 through 0F. The [UNIT ID] rotary switch will have a setting range of 10 through 1F. The [UNIT ID] rotary switch will have a setting range of 20 through 2F. The [UNIT ID] rotary switch will have a setting range of 30 through 3F. E [UNIT ID] rotary switch This switch specifies the ID by which EXi8/EXo8 units are individually distinguished in the MTX system network. You must specify the ID avoiding duplicates among the MTX series, XMV series and the EXi8/EXo8 within the same network. DIP switches 1 and 2 described in r specify the upper digit, and this rotary switch specifies the lower digit, together allowing you to set the UNIT ID to one of 63 possibilities in the range of 01 to 3F. [. . . ] Reduce the number of devices connected to the network. Set the UNIT ID to something other than “00. € 2 The current preset saved in internal memory has been lost. The word clock master has become unlocked. [. . . ]