User manual YAMAHA F115HP-2004

[. . . ] F115C LF115C OWNER'S MANUAL U. S. A. Edition LIT-18626-05-41 E EMU01448 TO THE OWNER Thank you for choosing a Yamaha outboard motor. This Owner's manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] NOTE: The use of "Yamaha Fuel Conditioner and Stabilizer" eliminates the need to drain the fuel system. Consult your Yamaha dealer or other qualified mechanic if the fuel system is to be drained instead. EMU00338 Flushing Cooling System and Fogging Engine Cooling system flushing is essential to prevent the cooling system from clogging up with salt, sand, or dirt. In addition, fogging of the engine is mandatory to prevent expensive engine damage due to rust. Perform the flushing and fogging at the same time. w 8 Do not touch or remove electrical parts when starting or during operation. 8 Keep hands, hair and clothes away from flywheel and other rotating parts while engine is running. 000353 EMU00342 q 8 Flushing with the Flushing Attachment cC Avoid running the outboard at high speed while on the flushing attachment, or overheating could occur. 1) 605014 2) Remove the top cowling and the propeller. Install a flushing attachment 1 to the cooling water inlet. 4-5 E 3) Run the engine at a fast idle for 10~15 minutes supplying fresh water. 4) Just prior to turning off the engine, quickly spray "Yamaha Stor-Rite Engine Fogging Oil" (Part No. LUBSTRRT-12-00) alternately into the silencer cover. When properly done, the engine will smoke excessively and almost stall. 5) Remove the flushing attachment and wipe off any excess water. 6) Install the top cowling and the propeller. NOTE: A flushing attachment is available from a Yamaha dealer. EMU00349* Lubrication 1) Remove the spark plug(s). Spray a Yamaha "Stor-Rite Engine Fogging Oil" into each cylinder for 5 seconds. Grease the spark plug threads and reinstall the spark plug(s) and torque to proper specification. (Refer to the "CLEANING AND ADJUSTING SPARK PLUG"). 2) Turn the engine over with the stop lanyard disconnected to work the fogging oil into the piston rings. (Refer to "CHANGING GEAR OIL"). Inspect the oil for the presence of water which indicates a leaky seal. Seal replacement should be performed by an authorized Yamaha dealership prior to use. (Refer to the "GREASING") 4-6 E EMU00352 Cleaning and Anti-corrosion Measure 1) Wash down the exterior of the outboard with fresh water and dry off completely. 2) Spray the engine's exterior with "Yamaha Silicone Protectant" (Part No. [. . . ] WARRANTY DEPARTMENT P. O. Box 6555 Cypress, California 90630 This will ensure that Yamaha Motor Corporation, U. S. A. has an up-to-date registration record in accordance with federal law. EMU01178 IMPORTANT WARRANTY INFORMATION IF YOU USE YOUR YAMAHA OUTSIDE U. S. A. OR CANADA Welcome to the Yamaha Family!Congratulations on the purchase of your new Yamaha marine power. [. . . ]