User manual YAMAHA F15HP

[. . . ] F9. 92 T9. 92 F15 OWNER'S MANUAL U. S. A. Edition LIT-18626-06-72 66M-28199-1C EMU25060 ZMU01690 Read this owner's manual carefully before operating your outboard motor. Important manual information EMU31280 To the owner Thank you for choosing a Yamaha outboard motor. This Owner's Manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] Then install the lock plate on the other end of the lanyard into the engine stop switch. 3. Place the throttle grip in the " " (start) position. After the engine starts, return the throttle to the fully closed position. EWM00120 WARNING G G G Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. Do not attach the lanyard to clothing that could tear loose. Do not route the lanyard where it could become entangled, preventing it from functioning. Avoid accidentally pulling the lanyard during normal operation. Loss of engine power means the loss of most steering control. Also, without engine power, the boat could slow rapidly. This could cause people and objects in the boat to be thrown forward. ZMU02027 4. Pull out / turn the choke knob fully. After the engine starts, replace / return the knob to the home position. ZMU02355 NOTE: G It is not necessary to use the choke when starting a warm engine. 32 Operation G If the choke knob is left in the " " (start) position while the engine is running, the engine will run poorly or stall. Push the starter button to start the motor. (Repeat if necessary. ) 5. repeat the procedure. If the engine fails to start after 4 or 5 tries, open the throttle a small amount (between 1/8 and 1/4) and try again. Also if the engine is warm and fails to start, open the throttle a same amount and try to start the engine again. If the engine still fails to start, see page 74. EMU27642 Electric start / remote control models 1. Place the remote control lever in neutral. ZMU04880 6. 7. Immediately after the engine starts, release the starter button to allow it to return to its original position. Slowly return the throttle grip to the fully closed position so that the engine does not stall. NOTE: The start-in-gear protection device prevents the engine from starting except when in neutral. Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg. Then install the lock plate on the other end of the lanyard into the engine stop switch. ECM00160 CAUTION: G G Never push the starter button while the engine is running. Do not keep the starter motor turning for more than 5 seconds. If the starter motor is turned continuously for more than 5 seconds, the battery will be quickly discharged, thus making it impossible to start the engine. If the engine will not start after 5 seconds of cranking, release the starter button, wait 10 seconds, then crank the engine again. When the engine is cold, it needs to be warmed up. [. . . ] Start-in-gear protection cable ZMU02026 3. Remove both ends of the choke link rod. 1 ZMU02332 ZMU02334 1. Choke link rod 6. 4. Remove the starter/flywheel cover after removing the 3 bolts. Disconnect the wire leads from the starter/flywheel cov- Pull up the lever on the carburetor to operate the choke system when the engine is cold. After the engine starts, return the lever to the original position. 79 Trouble Recovery EMU29783 Procedure 1. [. . . ]