User manual YAMAHA F25HP-1998

[. . . ] In this Owner's Manual particularly important information is distinguished in the following ways. The Safety Alert Symbol means ATTENTION!YOUR SAFETY IS INVOLVED! EWM00780 al, please consult your Yamaha dealer. NOTE: The F25MH, F25ER. F25TR, F25EH, T25TR and the standard accessories are used as a base for the explanations and illustrations in this manual. [. . . ] Symptoms include nausea, dizziness, and drowsiness. Keep cockpit and cabin areas well ventilated. If there is an air vent screw on the fuel tank cap, loosen it 2 or 3 turns. 1. ZMU02022 2. If there is a fuel joint on the motor, firmly connect the fuel line to the joint. Then firmly connect the other end of the fuel 30 Operation line to the joint on the fuel tank. EMU27490 Starting engine EMU27541 Starting engine 1. Place the gear shift lever in neutral. N ZMU02296 ZMU02304 NOTE: The start-in-gear protection device prevents the engine from starting except when in neutral. 2. ZMU02024 3. If a steering friction adjuster is provided on your outboard motor, securely attach the fuel line to the fuel line clamp. Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg. Then install the lock plate on the other end of the lanyard into the engine stop switch. NOTE: During engine operation place the tank horizontally, otherwise fuel cannot be drawn from the fuel tank. Squeeze the primer pump with the outlet end up until you feel it become firm. EWM00120 WARNING G G G ZMU02025 Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. Do not attach the lanyard to clothing that could tear loose. Do not route the lanyard where it could become entangled, preventing it from functioning. Avoid accidentally pulling the lanyard during normal operation. If the engine is warm and fails to start, open the throttle slightly and try to start the engine again. If the engine still fails to start, see page 72. NOTE: ZMU02335 G 4. Push the starter button to start the engine. G EMU27662 Electric start and remote control models 1. Place the remote control lever in neutral. 33 Operation NOTE: The start-in-gear protection device prevents the engine from starting except when in neutral. Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg. Then install the lock plate on the other end of the lanyard into the engine stop switch. 3. 4. Turn the main switch to " " (on). Turn the main switch to " " (start), and hold it for a maximum of 5 seconds. EWM00120 WARNING G G G Attach the engine stop switch lanyard to a secure place on your clothing, or your arm or leg while operating. Do not attach the lanyard to clothing that could tear loose. Do not route the lanyard where it could become entangled, preventing it from functioning. Avoid accidentally pulling the lanyard during normal operation. Loss of engine power means the loss of most steering control. [. . . ] You could get an electrical shock. EMU30290 Emergency starting engine 1. Remove the start-in-gear protection cable from the starter after removing the clip and the screw, if the cable is equipped. 4. ZMU02649 Prepare the engine for starting. Be sure the engine is in neutral and that the engine stop switch lanyard lock plate is attached to the engine stop switch. [. . . ]