User manual YAMAHA F40HP-2002

[. . . ] F30A F40A OWNER'S MANUAL U. S. A. Edition LIT-18626-04-71 E EMU01449 TO THE OWNER Thank you for choosing a Yamaha outboard motor. This Owner's manual contains information needed for proper operation, maintenance and care. A thorough understanding of these simple instructions will help you obtain maximum enjoyment from your new Yamaha. If you have any question about the operation or maintenance of your outboard motor, please consult a Yamaha dealer. [. . . ] Run the engine at a fast idle for 10~15 minutes. Just prior to turning off the engine, quickly spray "Yamaha Stor-Rite Engine Fogging Oil" (Part No. LUBSTRRT-12-00) alternately into each carburetor. When properly done, the engine will smoke excessively and almost stall. 4-5 E 6) Remove the motor from the water tank. Install the silencer cover and top cowling. q w 7) 1 Water surface 2 Lowest water level 605024 EMU00342 8 Flushing with the Flushing Attachment cC Avoid running the outboard at high speed while on the flushing attachment, or overheating could occur. q 903021* 605014 Remove the top cowling and the propeller. 2) Install a flushing attachment 1 to the cooling water inlet. 3) Run the engine at a fast idle for 10~15 minutes supplying fresh water. 4) Just prior to turning off the engine, quickly spray "Yamaha Stor-Rite Engine Fogging Oil" (Part No. LUBSTRRT-12-00) alternately into the silencer cover. When properly done, the engine will smoke excessively and almost stall. 5) Remove the flushing attachment and wipe off any excess water. 6) Install the top cowling and the propeller. NOTE: A flushing attachment is available from a Yamaha dealer. 1) 4-6 E EMU00349 Lubrication 1) Remove the spark plug(s). Spray a Yamaha "Stor-Rite Engine Fogging Oil" into each cylinder for 10 seconds. Grease the spark plug threads and reinstall the spark plug(s) and torque to proper specification. (Refer to the "CLEANING AND ADJUSTING SPARK PLUG"). 2) Turn the engine over with the stop lanyard disconnected to work the fogging oil into the piston rings. (Refer to "CHANGING GEAR OIL"). Inspect the oil for the presence of water which indicates a leaky seal. Seal replacement should be performed by an authorized Yamaha dealership prior to use. (Refer to the "GREASING") EMU00351 Cleaning and Anti-corrosion Measure 1) Wash down the exterior of the outboard with fresh water and dry off completely. 2) Spray the engine's exterior with "Yamaha Silicone Protectant" (Part No. [. . . ] don't forget to include any important information such as names, addresses, model, engine serial number, dates, and receipts. CHANGE OF ADDRESS The federal government requires each manufacturer of a motor vehicle to maintain a complete, up-to-date list of all first purchasers against the possibility of a safety-related defect and recall. This list is complied from the purchase registrations sent to Yamaha Motor Corporation, U. S. A. by the selling dealer at the time of your purchase. [. . . ]