User manual YAMAHA F9.9HP-1999

[. . . ] In this Owner's Manual particularly important information is distinguished in the following ways. cC A CAUTION indicates special precautions that must be taken to avoid damage to the outboard motor. NOTE: A NOTE provides key information to make procedures easier or clearer. * Yamaha continually seeks advancements in product design and quality. Therefore, while this manual contains the most current product information available at the time of printing, there may be minor discrepancies between your machine and this manual. [. . . ] Severe injury could occur if the outboard accidentally falls. 8 USE CARE when transporting fuel tank, whether in a boat or car. 8 DO NOT fill fuel container to maximum capacity. Gasoline will expand considerably as it warms up and can build up pressure in the fuel container. This can cause fuel leakage and a potential fire hazard. cC Do not use the tilt support lever/knob when trailering the boat. The outboard motor could shake loose from the tilt support and fall. If the motor can not be trailered in the down position, use an additional support device to secure it in the up position. 4-3 E EMU00330 STORING OUTBOARD MOTOR When storing your Yamaha outboard for prolonged periods of time, (2 months or longer), several important procedures must be performed to prevent expensive damage. It is advisable to have your outboard serviced by an authorized Yamaha dealer prior to storage. However, the following procedures can be performed by you, the owner, with a minimum of tools. cC 8 To prevent problems which can be caused by oil entering the cylinder from the sump, keep the engine in the attitude shown when transporting and storing it. 8 Do not place the engine on its side before the cooling water has drained from it completely, or water may enter the cylinder through the exhaust port and cause problems. 6) Install the top cowling and the propeller. NOTE: A flushing attachment is available from a Yamaha dealer. 4-6 E EMU00349 Lubrication 1) Remove the spark plug(s). Spray a Yamaha "Stor-Rite Engine Fogging Oil" into each cylinder for 10 seconds. Grease the spark plug threads and reinstall the spark plug(s) and torque to proper specification. (Refer to the "CLEANING AND ADJUSTING SPARK PLUG"). 2) Turn the engine over with the stop lanyard disconnected to work the fogging oil into the piston rings. (Refer to "CHANGING GEAR OIL"). Inspect the oil for the presence of water which indicates a leaky seal. Seal replacement should be performed by an authorized Yamaha dealership prior to use. (Refer to the "GREASING") EMU00351 Cleaning and Anti-corrosion Measure 1) Wash down the exterior of the outboard with fresh water and dry off completely. 2) Spray the engine's exterior with "Yamaha Silicone Protectant" (Part No. [. . . ] This list is complied from the purchase registrations sent to Yamaha Motor Corporation, U. S. A. by the selling dealer at the time of your purchase. If you should move after you have purchased your new outboard, please advise us of your new address by sending a postcard listing your outboard model name, engine serial number, dealer number (or dealer's name) as it is shown on your warranty identification, your name and new mailing address. Mail to: YAMAHA MOTOR CORPORATION, U. S. A. [. . . ]