User manual YAMAHA FJR1300-2003

[. . . ] OWNER'S MANUAL FJR1300 FJR1300A 5JW-28199-E2 EAU04980 CM-01E DECLARATION of CONFORMITY We Company: MORIC CO. , LTD. Address: 1450-6 Mori Mori-Machi Shuchi-gun Shizuoka 437-0292 Japan Hereby declare that the product: Kind of equipment: IMMOBILIZER Type-designation: 5SL-00, 5VS-00, 5VX-00, 3HT-00, 5UX-00, 5UX-10, 5KS-00 and 5KS-10 is in compliance with following norm(s) or documents: R&TTE Directive(1999/5/EC) EN300 330-2 v1. 1. 1(2001-6), EN60950(2000) Two or Three-Wheel Motor Vehicles Directive(97/24/EC: Chapter 8, EMC) Place of issue: Shizuoka, Japan Date of issue: Aug. 1st 2002 Kazuji Kawai representative name and signature EAU04575 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of the FJR1300/FJR1300A, you are benefiting from Yamaha's vast experience and newest technology regarding the design and manufacture of highquality products, which have earned Yamaha a reputation for dependability. [. . . ] Screw (× 3) EAU01315 6 Panel D To remove the panel Remove the screws, and then take the panel off. To install the panel Place the panel in the original position, and then install the screws. 1. Quick fastener (× 3) EAU04506 Panels E and F To remove one of the panels 1. (See page 3-17 for seat removal and installation procedures. ) 2. Remove the screws, the quick fastener screw and the quick fasteners, and then take the panel off. Place the panel in the original position, and then install the quick fasteners and quick fastener screw, and tighten the screws. Install the seats. 6-7 PERIODIC MAINTENANCE AND MINOR REPAIR Specified spark plug: CR8E (NGK) or U24ESR-N (DENSO) NOTE: If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4­1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. _ _ a. Spark plug gap Before installing a spark plug, the spark plug gap should be measured with a wire thickness gauge and, if necessary, adjusted to specification. 6 Spark plug gap: 0. 7­0. 8 mm Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. Tightening torque: Spark plug: 12. 5 Nm (1. 25 m·kgf) 6-8 PERIODIC MAINTENANCE AND MINOR REPAIR EAU05018 Engine oil and oil filter cartridge The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. Place the motorcycle on the centerstand. 6 NOTE: Make sure that the motorcycle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. _ _ 1. Wait a few minutes until the oil settles, and then check the oil level through the check window located at the bottom-left side of the crankcase. NOTE: The engine oil should be between the minimum and maximum level marks. _ _ 2. Start the engine, warm it up for several minutes, and then turn it off. 4. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. To change the engine oil (with or without oil filter cartridge replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. Place an oil pan under the engine to collect the used oil. Remove the engine oil filler cap and drain bolt to drain the oil from the crankcase. [. . . ] 6-7 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-1 Speedometer. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 Starting the engine . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1 Start switch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]