User manual YAMAHA FP9000/8000

[. . . ] If you have any questions concerning the operation or maintenance of your motorcycle, please consult a Yamaha dealer. The design and manufacture of this Yamaha motorcycle fully comply with the emissions standards for clean air applicable at the date of manufacture. Yamaha has met these standards without reducing the performance or economy of operation of the motorcycle. To maintain these high standards, it is important that you and your Yamaha dealer pay close attention to the recommended maintenance schedules and operating instructions contained within this manual. IMPORTANT MANUAL INFORMATION EAU10130 Particularly important information is distinguished in this manual by the following notations: The Safety Alert Symbol means ATTENTION! [. . . ] Remove the oil filter element cover by removing the bolts. 1. If the engine oil is below the minimum level mark, add sufficient oil of the recommended type to raise it to the correct level. To change the engine oil (with or without oil filter element replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. 5. Remove and replace the oil filter element and O-ring. 1. Engine oil drain bolt 6-11 PERIODIC MAINTENANCE AND MINOR REPAIR Tightening torque: Engine oil drain bolt: 34 Nm (3. 4 m·kgf, 24 ft·lbf) G Make sure that no foreign material enters the crankcase. 8. Add the specified amount of the recommended engine oil, and then install and tighten the oil filler cap. Recommended engine oil: See page 8-1. Oil quantity: With oil filter element replacement: 1. 60 L (1. 69 US qt) (1. 41 Imp. qt) Without oil filter element replacement: 1. 40 L (1. 48 US qt) (1. 23 Imp. qt) ECA11620 1. Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause. Turn the engine off, and then check the oil level and correct it if necessary. 6. Install the air filter case bolts. 6-14 PERIODIC MAINTENANCE AND MINOR REPAIR EAU21381 EAU21401 EAU32520 Checking the throttle cable free play Valve clearance The valve clearance changes with use, resulting in improper air-fuel mixture and/or engine noise. To prevent this from occurring, the valve clearance must be adjusted by a Yamaha dealer at the intervals specified in the periodic maintenance and lubrication chart. Tires To maximize the performance, durability, and safe operation of your motorcycle, note the following points regarding the specified tires. Tire air pressure The tire air pressure should be checked and, if necessary, adjusted before each ride. EWA10500 WARNING 1. Throttle cable free play G The throttle cable free play should measure 3. 0­5. 0 mm (0. 12­0. 20 in) at the throttle grip. Periodically check the throttle cable free play and, if necessary, have a Yamaha dealer adjust it. G The tire air pressure must be checked and adjusted on cold tires (i. e. , when the temperature of the tires equals the ambient temperature). The tire air pressure must be adjusted in accordance with the riding speed and with the total weight of rider, passenger, cargo, and accessories approved for this model. 6 6-15 PERIODIC MAINTENANCE AND MINOR REPAIR Tire air pressure (measured on cold tires): 0­90 kg (0­198 lb): Front: 175 kPa (25 psi) (1. 75 kgf/cm²) Rear: 200 kPa (29 psi) (2. 00 kgf/cm²) XV250V 90­196 kg (198­432 lb) XV250VC 90­195 kg (198­430 lb): Front: 200 kPa (29 psi) (2. 00 kgf/cm²) Rear: 225 kPa (33 psi) (2. 25 kgf/cm²) Maximum load*: XV250V 196 kg (432 lb) XV250VC 195 kg (430 lb) * Total weight of rider, passenger, cargo and accessories EWA10510 and check the condition and pressure of your tires. Make sure that the total weight of the cargo, rider, passenger, and accessories (cowling, saddlebags, etc. if approved for this model) does not exceed the maximum load of the vehicle. Operation of an overloaded vehicle could cause tire damage, an accident, or even injury. Tire inspection if the tire has a nail or glass fragments in it, or if the sidewall is cracked, contact a Yamaha dealer immediately and have the tire replaced. Minimum tire tread depth (front and rear): 1. 0 mm (0. 04 in) EWA10560 WARNING G 6 G WARNING Proper loading of your vehicle is important for several characteristics of your vehicle, such as handling, braking, performance and safety. Do not carry loosely packed items that can shift. [. . . ] 9-5 Model label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-2 D Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3 Drive chain, cleaning and lubricating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-25 Drive chain slack. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]