User manual YAMAHA FZ6-2005

[. . . ] If you have any questions concerning the operation or maintenance of your motorcycle, please consult a Yamaha dealer. The design and manufacture of this Yamaha motorcycle fully comply with the emissions standards for clean air applicable at the date of manufacture. Yamaha has met these standards without reducing the performance or economy of operation of the motorcycle. To maintain these high standards, it is important that you and your Yamaha dealer pay close attention to the recommended maintenance schedules and operating instructions contained within this manual. IMPORTANT MANUAL INFORMATION EAU10131 Particularly important information is distinguished in this manual by the following notations: The Safety Alert Symbol means ATTENTION! [. . . ] G Make sure that the canister breather is not blocked, and if necessary, clean it. PERIODIC MAINTENANCE AND MINOR REPAIR NOTE: An oil filter wrench is available at a Yamaha dealer. Apply a thin coat of engine oil to the O-ring of the new oil filter cartridge. 1. Insert and tighten the engine oil dipstick, and then install and tighten the oil filler cap. 6 To change the engine oil (with or without oil filter cartridge replacement) 1. Start the engine, warm it up for several minutes, and then turn it off. Place an oil pan under the engine to collect the used oil. Remove the engine oil filler cap and drain bolt to drain the oil from the crankcase. NOTE: Skip steps 4­6 if the oil filter cartridge is not being replaced. Remove the oil filter cartridge with an oil filter wrench. 1. O-ring NOTE: Make sure that the O-ring is properly seated. Install the new oil filter cartridge with an oil filter wrench, and then tighten it to the specified torque with a torque wrench. 1. Oil filter wrench 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR Recommended engine oil: See page 8-1. Place a container under the engine to collect the used coolant. Remove the radiator cap retaining bolt, radiator cap retainer and radiator cap. EWA10380 WARNING Never attempt to remove the radiator cap when the engine is hot. 1. Coolant reservoir WARNING Never attempt to remove the radiator cap when the engine is hot. NOTE: G The radiator fan is automatically switched on or off according to the coolant temperature in the radiator. G If the engine overheats, see page 6-42 for further instructions. EAU42680 5. Remove the coolant reservoir cover and coolant reservoir by removing the bolts. Place the vehicle on the centerstand and let the engine cool if necessary. 1. Drain the coolant from the coolant reservoir by turning it upside down. 6-15 PERIODIC MAINTENANCE AND MINOR REPAIR 7. Install the coolant reservoir and its reservoir cover by placing them in the original position, and then installing the bolts. Remove the coolant drain bolt to drain the cooling system. Tightening torque: Coolant drain bolt: 10 Nm (1. 0 m·kgf, 7. 2 ft·lbf) G 11. Pour the specified amount of the recommended coolant into the radiator and reservoir. Antifreeze/water mixture ratio: 1:1 Recommended antifreeze: High-quality ethylene glycol antifreeze containing corrosion inhibitors for aluminum engines Coolant quantity: Radiator capacity (including all routes): 2. 00 L (2. 11 US qt) (1. 76 Imp. qt) Coolant reservoir capacity (up to the maximum level mark): 0. 25 L (0. 26 US qt) (0. 22 Imp. qt) ECA10471 G If water has been used instead of coolant, replace it with coolant as soon as possible, otherwise the cooling system will not be protected against frost and corrosion. [. . . ] 6-23 Coolant . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-14 Coolant temperature warning light. . . . . . . . . . 3-2 I Identification numbers . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-1 Ignition circuit cut-off system . . . . . . . . . . . . . . . . . 3-16 Indicator and warning lights . . . . . . . . . . . . . . . . . . . . 3-2 K Key identification number. . . . . . . . . . . . . . . . . . . . . . . . 9-1 L Labels, location of . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-5 License plate light bulb, replacing . . . . . . . . . 6-38 M Main switch/steering lock . . . . . . . . . . . . . . . . . . . . . . . . 3-1 Maintenance and lubrication, periodic. . . . . 6-4 Maintenance, emission control system . . . 6-3 Maintenance, periodic . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6-1 Maintenance record . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-5 Matte color, caution. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7-1 Model label. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-2 Multi-function meter unit. . . . . . . . . . . . . . . . . . . . . . . . . . 3-4 D Dimmer switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-8 Drive chain, cleaning and lubricating. . . . [. . . ]