User manual YAMAHA FZ6-SHG-2007

[. . . ] OWNER'S MANUAL FZ6-SHG 4S8-28199-EA EAU26943 DECLARATION of CONFORMITY We Company: MORIC CO. , LTD. Address: 1450-6 Mori Mori-Machi Shuchi-gun Shizuoka 437-0292 Japan Hereby declare that the product: Kind of equipment: IMMOBILIZER Type-designation: 5SL-00 is in compliance with following norm(s) or documents: R&TTE Directive(1999/5/EC) EN300 330-2 v1. 1. 1(2001-6), EN60950-1(2001) Two or Three-Wheel Motor Vehicles Directive(97/24/EC: Chapter 8, EMC) Place of issue: Shizuoka, Japan Date of issue: 1 Aug. Contents To change contact person and integrate type-designation. 1 Version up the norm of EN60950 to EN60950-1 2 Date 9 Jun. [. . . ] Bolt 6-6 PERIODIC MAINTENANCE AND MINOR REPAIR 1. Bolt Panel C 6 To remove the panel 1. Remove the bolts, and then take the panel off. To install the panel 1. Place the panel in the original position, and then install the bolts. Install panels A and B. EAU33020 To install the panel 1. Place the panel in the original position, and then install the bolt. Panel D To remove the panel 1. Remove the bolt, and then pull the panel off as shown. Install the seat. 6-7 PERIODIC MAINTENANCE AND MINOR REPAIR EAU19642 Checking the spark plugs The spark plugs are important engine components, which should be checked periodically, preferably by a Yamaha dealer. Since heat and deposits will cause any spark plug to slowly erode, they should be removed and checked in accordance with the periodic maintenance and lubrication chart. In addition, the condition of the spark plugs can reveal the condition of the engine. The porcelain insulator around the center electrode of each spark plug should be a medium-to-light tan (the ideal color when the vehicle is ridden normally), and all spark plugs installed in the engine should have the same color. If any spark plug shows a distinctly different color, the engine could be operating improperly. Do not attempt to diagnose such problems yourself. Instead, have a Yamaha dealer check the vehicle. If a spark plug shows signs of electrode erosion and excessive carbon or other deposits, it should be replaced. Specified spark plug: NGK/CR9EK Before installing a spark plug, the spark plug gap should be measured with a wire thickness gauge and, if necessary, adjusted to specification. NOTE: If a torque wrench is not available when installing a spark plug, a good estimate of the correct torque is 1/4­1/2 turn past finger tight. However, the spark plug should be tightened to the specified torque as soon as possible. 1. Spark plug gap Spark plug gap: 0. 6­0. 7 mm (0. 024­0. 028 in) 6 Clean the surface of the spark plug gasket and its mating surface, and then wipe off any grime from the spark plug threads. Tightening torque: Spark plug: 17. 5 Nm (1. 75 m·kgf, 12. 7 ft·lbf) 6-8 PERIODIC MAINTENANCE AND MINOR REPAIR EAU42620 Engine oil and oil filter cartridge The engine oil level should be checked before each ride. In addition, the oil must be changed and the oil filter cartridge replaced at the intervals specified in the periodic maintenance and lubrication chart. NOTE: Make sure that the vehicle is positioned straight up when checking the oil level. A slight tilt to the side can result in a false reading. Start the engine, warm it up for several minutes, and then turn it off. Wait a few minutes until the oil settles. [. . . ] 7-1 Model label . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9-2 Multi-function meter unit . . . . . . . . . . . . . . . . . . . . . . . . . 3-6 T Tail/brake light bulb, replacing . . . . . . . . . . . . . . 6-33 Throttle cable free play, checking . . . . . . . . . 6-17 Throttle grip and cable, checking and lubricating . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]