User manual YAMAHA G100III

[. . . ] ) Setting the "Tremolo Unit Holder" 1 Turn the tremolo arm towards the body end. (Fig. ) Turn the arm this way Pop in/out the arm Tremolo arm Out In 2 Set the "Tremolo Unit Holder" as shown in illustration. [. . . ] (Fig. ) * The "Tremolo Unit Holder" helps to keep the tremolo unit stable and horizontal for easy string change and re-tuning. Adjusting the torque of the tremolo arm To adjust the torque of the tremolo arm, tighten or loosen the screw on the side of the "arm base" with a hexagonal wrench. ) * Attach the tremolo arm before adjusting the torque. Set "Tremolo Unit Holder" Adjust the arm torque Loosen Arm Base Tighten Tremolo Unit Holder * When setting the "Tremolo Unit Holder", Adjust the height by rotating the head so the tremolo unit is parallel to the top of the guitar body. ) Adjust holder height Raise Lower QC88670 Printed in Taiwan 1 English Part 1 : Setting up the tremolo arm & tremolo unit holder Part 2 : Removing the old strings 1 Loosen the locking lever of the FC (FingerClamp) nut. ) 4 Remove the old strings from the body back. (Fig. ) Loosen the locking nut * It is not needed to detach the back cover to remove the strings. Pull off old strings English Locking Lever Loosen 2 Pull up the locking levers of the FC tremolo. (Fig. ) Pull up the locking lever Locking Lever 3 Loosen the tuning machines to remove the old strings from the tuning machines in the standard manner. ) Remove old strings * The "Tremolo Unit Holder" prevents the tremolo unit from sinking into the tremolo cavity. ) * All the string heights can be set properly by adjusting the two bolts. 2 Adjust the location of the bridge saddle with the hexagonal wrench. ) a) If the fretted tone at the 12th fret is higher in pitch than the harmonic tone at the 12th fret, rotate the intonation screw clockwise to move the bridge saddle backwards. b) If the fretted tone at the 12th fret is lower in pitch than the harmonic tone at the 12th fret, rotate the intonation screw counter-clockwise to move the bridge saddle forwards. English Adjust string height Move the bridge saddle Lower action Bridge Saddle Higher action a) Backward b) Forward Intonation adjustment 1 To adjust the intonation of each string, pull up the locking lever of the FC tremolo (Fig. ) and loosen the screw inside the bridge saddle. ) 3 4 Tighten the screw inside the bridge saddle. (Fig. ) Return the locking lever of the FC tremolo to the original position. ) Unlock the bridge saddle Tighten Loosen Part 5 : Adjusting the Truss Rod 1 Loosen two screws of the truss rod cover with the Phillips head screw driver. [. . . ] ) Unlock the bridge saddle Tighten Loosen Part 5 : Adjusting the Truss Rod 1 Loosen two screws of the truss rod cover with the Phillips head screw driver. ) 2 Rotate the truss rod nut with the screw driver. [. . . ]