User manual YAMAHA GX-700RDS

[. . . ] GB DISC 1 DISC 2 DISC 3 DISC CHANGE OPEN / CLOSE 3­DISC CD CHANGER PTY SELECT PRESET/ TUNING/ BAND A/B/C/D/E VOLUME DOWN UP STANDBY TIMER PROGRAM B. BOOST MUSIC INPUT INPUT PUSH OPEN MINI COMPONENT SYSTEM GX­700 STANDBY/ON AUTO REVERSE CASSETTE DECK DOLBY B NR DIRECTION OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING Unpacking Déballage Auspacken Uppackning Disimballaggio Desembalaje Uitpakken q q q q q q q Main unit Appareil principal Gerät Huvudapparat Apparecchio principale Aparato principal Hoofdeenheid q q q q q q q After unpacking, check that the following parts are contained. Après le déballage, vérifier que les pièces suivantes sont incluses. Nach dem Auspacken überprüfen, ob die folgenden Teile vorhanden sind. Kontrollera efter det apparaten packats upp att följande delar finns med. [. . . ] (Refer to page 24 for details. ) q With this function, only stations with sufficient signal strength are stored automatically. If the station you want to program is weak in signal strength, tune in to it with the Manual tuning method (in monaural) and program it by following the procedure of the section "To store stations" on the previous page. q You can replace a preset station with another FM or AM station manually by simply following the procedure of the section "To store stations" on the previous page. Memory back-up The memory back-up circuit prevents the programmed data from being lost even if the AC supply lead is disconnected from the AC outlet or the power is cut due to temporary power failure. If, however, the power is cut for more than one week, the memory may be erased. If so, it can be re-programmed by simply following the Preset tuning steps. E-20 English Tuning operation Receiving RDS stations RDS (Radio Data System) is a data transmission system employed by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal. RDS data contains various information, such as PI (Program Identification), PS (Program Service name), PTY (Program Type), RT (Radio Text), CT (Clock Time), etc. RDS function is carried out among the network stations. * The built-in tuner utilizes PS, PTY, RT and CT to receive RDS broadcast stations. RDS modes The built-in tuner uses the following four modes to display RDS data. PS (Program Service name) mode PTY (Program Type) mode There are 15 program types to classify RDS stations as described below. RT (Radio Text) mode CT (Clock Time) mode PTY modes NEWS AFFAIRS INFO SPORT EDUCATE DRAMA CULTURE SCIENCE News Current affairs General information Sports Education Drama Culture Science VARIED POP M ROCK M M. O. R. M LIGHT M CLASSICS OTHER M Light entertainment Pops Rock Middle of the road music (easy-listening) Light classics Serious classics Other music Changing the RDS modes DISC 1 DISC 2 DISC 3 DISC CHANGE OPEN / CLOSE PTY SELECT PRESET/ TUNING/ BAND A/B/C/D/E VOLUME DOWN UP FREQ PS/PTY/RT/CT PROGRAM B. BOOST MUSIC INPUT INPUT FREQ PS/PTY/RT/CT RANDOM MODE­PTY SEEK­ START REPEAT TIME HOUR MIN MODE DOLBY NR REC/PAUSE AUTO/MANUAL MEMORY DISPLAY TIMER TIME ADJ When an RDS station is received, by pressing FREQ PS/PTY/ RT/CT once or more, you can change the display mode among the RDS modes employed by the received station in the order shown on the next page. (The RDS mode not employed by the station cannot be selected. ) Notes If the received station is not an RDS station, pressing FREQ PS/PTY/RT/CT displays "NO RDS" on the display, and then it returns to the frequency display mode. When an RDS station is received, the display is automatically turned into the PS mode. Do not press FREQ PS/PTY/RT/CT until the display is turned into the PS mode. If the button is pressed before the display mode changes, it may occur that "NO PS" appears on the display. This is because the tuner has not received all of the RDS data on the station yet. STANDBY/ON DIRECTION E-21 Tuning operation 1 Frequency 1 Frequency display mode display mode The frequency of the station being received is displayed. 2 PS (Program Service name) mode 2 PS mode The name of the station being received is displayed using characters selected from among 64 Roman Alphabets including umlaut sign. * If other characters are used on the PS data, they are replaced by underbars. * "PS WAIT" may flash while the tuner is receiving the data. * If the station does not employ the PS data service, "NO PS" lights up on the display for about 2 seconds and then returns to the frequency display mode. 3 PTY mode FREQ PS/PTY/RT/CT RANDOM 3 PTY (Program Type) mode The type of the program on the station being received is displayed. In this mode, you can make this unit search for a station which is broadcasting a program of your desired program type. * If the RDS station does not employ the PTY data service, "NO PTY" lights up on the display for about 2 seconds and then returns to the frequency display mode. If the station has PS data, after that, it turns into the PS mode. 4 RT mode 4 RT (Radio Text) mode Information about the program on the station being received is displayed. Information is displayed by a maximum of 64 Roman Alphabets including umlaut sign. [. . . ] 87. 50 to 108. 00 MHz AM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 531 to 1, 611 kHz Usable Sensitivity (FM) 75 ohm, DIN, Mono, S/N 26 dB . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1. 8 µV S/N 30 dB, 1 kHz, 100% Mod. 1. 5 µV General CD player section Type . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]