User manual YAMAHA HI-HAT STAND

[. . . ] t Connecting Rod o Heel A removable rubber base is attached to the underside of the heel. Remarry the rubber, reveals a strip of VelcroTM that, provides better grip when the stand is used on carpeted surfaces, etc. [. . . ] To maintain smooth action, apply some grease-grade oil (ex. lithium grease) to all of the moving parts as needed. i Adjust the Footboard Angle The angle adjuster can be used to increase or decrease the amount of footboard angle by raising or lowering the adjuster. With a drum key, loosen the two bolts on either side of the angle adjuster then slide the angle adjuster higher or lower as needed. After the angle has been determined, firmly tighten two bolts with a drum key. Protect Sheet · * Specifications and design are subject to change without notice. Note) Moving parts require occasional lubrication for smooth operation. Also, over tightening of the nylon clutch inside the base assembly's pipe holder may result in damage. Please use caution. Pipe Holder Bolt q Cymbal Support Plate To attach the bottom hi-hat cymbal first, remove the hi-hat clutch and set the bottom hi-hat cymbal on the rubber washer. At this time, make sure that the metal plate and the rubber washer are on the cymbal support plate. Rotate the knurled head bolt, located under the plate, to adjust the angle of the cymbal then secure with the fixing nut. [. . . ] After the position has been determined, tighten the drum key bolt w to lock the lock nut in place. The drum key bolt w can be locked with a minimum of force so be sure not to over tighten which may cause damage to the bolt. Angle Adjuster Footboard Footboard Spikes Heel Spikes Heel Spikes Heel Printed in Japan [. . . ]