User manual YAMAHA HTIB-305

[. . . ] G YST -SW01 5 Subwoofer System Enceinte a caisson de grave OWNER'S MANUAL MODE D'EMPLOI BEDIENUNGSANLEITUNG BRUKSANVISNING MANUALE DI ISTRUZIONI MANUAL DE INSTRUCCIONES GEBRUIKSAANWIJZING Thank you for selecting this YAMAHA Subwoofer System. English CAUTION: Read this before operating your unit. Please read the following operating precautions before use. YAMAHA will not be held responsible for any damage and/or injury caused by not following the cautions below. To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a cool, dry, clean place ­ away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. [. . . ] and Europe models . . . . . . . . . . . . . . . . . . . . . . . . AC 230V, 50 Hz Australia model . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 240V, 50 Hz China, Korean and General models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120/220-240V, 50/60 Hz Dimensions (W x H x D) . . . . . 280 mm x 325 mm x 320 mm (11" x 12-13/16" x 12-5/8") Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 oz. ) Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 W Standby Power Consumption . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0. 8 W * Specifications are subject to change without notice due to product improvements. E-2 PLACEMENT Å i English ( : subwoofer, : main speaker) It is recommended to place the subwoofer on the outside of either the right or the left main speaker. i is also possible, however, if the subwoofer system is placed directly facing the wall, the bass effect may die because the sound from it and the sound reflected by the wall may cancel out each other. To prevent this from happening, face the subwoofer system at an angle as shown in fig. Note There may be a case that you cannot obtain enough superbass sounds from the subwoofer when listening in the center of the room. This is because "standing waves" have been developed between two parallel walls and they cancel the bass sounds. In such a case, face the subwoofer obliquely to the wall. It also may be necessary to break up the parallel surfaces by placing bookshelves etc. along the walls. Use the non-skid pads Put the provided non-skid pads at the four corners on the bottom of the subwoofer to prevent the subwoofer from moving by vibrations etc. SUBWOOFER STANDBY/ON SYSTEM B. A. S. S. YST-SW015 VOLUME 0­10 HIGH CUT50­150Hz I About this manual · This manual is printed prior to production. Design and specifications are subject to change in part for the reason of the improvement in operativity ability, and others. · Some of the illustrations and names of the package contents etc. written in this manual may differ from the actual products and the names written on the package etc. E-3 CONNECTIONS Caution: Plug in the subwoofer and other audio/video components after all connections are completed. Connect the subwoofer to the line output (pin jack) terminal(s) of the amplifier. When connecting the subwoofer to the SPLIT SUBWOOFER terminals on the rear of the DSP amplifier, be sure to connect the L/MONO INPUT terminal to the "L" side and the R INPUT terminal to the "R" side of the SPLIT SUBWOOFER terminals. To connect with a YAMAHA DSP amplifier (or AV receiver), connect the SUBWOOFER (or LOW PASS etc. ) terminal on the rear of the DSP amplifier (or AV receiver) to the L/MONO INPUT terminal of the subwoofer. Right main speaker Left main speaker Subwoofer cable (not included) Subwoofer INPUT /MONO AUTO STANDBY PHASE OFF LOW HIGH NORM REV INPUT /MONO AUTO STANDBY PHASE OFF LOW HIGH NORM REV 110V­120V 220V­240V VOLTAGE SELECTOR POWER ON OFF To AC outlet Audio pin cable (not included) SPLIT SUBWOOFER Amplifier SUBWOOFER (LOW PASS) Notes Some amplifiers have line output terminals labeled PRE OUT. When you connect the subwoofer to the PRE OUT terminals of the amplifier, make sure that the amplifier has at least two sets of PRE OUT terminals. If the amplifier has only one set of PRE OUT terminals, do not connect the subwoofer to the PRE OUT terminals. When connecting to a monaural line output terminal of the amplifier, connect the L/MONO INPUT terminal. E-4 English CONTROLS AND THEIR FUNCTIONS Front panel SUBWOOFER SYSTEM YST-SW015 STANDBY/ON B. A. S. S. [. . . ] Speaker cables are not connected securely. Speaker cables are not connected correctly. Setting of the PHASE switch is not proper. A source sound with few bass frequencies is played. [. . . ]