User manual YAMAHA INVERTER

[. . . ] Generator OWNER'S MANUAL EF2800i YG2800i LIT-19626-01-13 7VU-28199-12 AE00002 INTRODUCTION Congratulations on your purchase of your new Yamaha. This manual will provide you with a good basic understanding of the operation and maintenance of this machine. If you have any questions regarding the operation or maintenance of your machine, please consult a Yamaha dealer. CODE AE00012 SERIAL No. IDENTIFICATION NUMBER RECORDS Record your Primary I. D. , and serial numbers in the spaces provided, to assist you in ordering spare parts from a Yamaha dealer. [. . . ] Have the equipment inspected and repaired by a qualified repairperson before attempting to use it again. w TO REDUCE THE CHANCE OF ELECTRICAL SHOCK: 9 Do not attempt to operate equipment if the ground fault circuit interrupter reset button pops out repeatedly during use. 9 Test the ground fault circuit interrupter during the pre-operation checks according to the maintenance instructions on page 30. 9 Remember that only receptacles labeled "GFCI" have ground fault circuit interrupter protection. ­ 11 ­ AE00845 PRE-OPERATION CHECK NOTE: Pre-operation checks should be made each time the generator is used. w The engine and muffler will be very hot after the engine has been run. Avoid touching the engine and muffler while they are still hot with any part of your body or clothing during inspection or repair. AE00856 741-001 FUEL Make sure there is sufficient fuel in the tank. Recommended fuel: Unleaded gasoline Fuel tank capacity: Total: 11. 2 L (2. 46 Imp gal, 2. 96 US gal) Your Yamaha engine has been designed to use regular unleaded gasoline with a pump octane number ((R + M)/2) of 86 or higher, or research octane number of 91 or higher. 707-001 q 707-033a 1 Fuel level gauge "F" "E" Full Empty w 707-037 9 Fuel is highly flammable and poisonous. Check "SAFETY INFORMATION" (See page 5) carefully before refueling. 9 Do not fill above the top of the fuel filter or it may overflow when the fuel heats up later and expands. 9 After refueling, make sure the tank cap is tightened securely. ­ 12 ­ 707-051 AE00222 ENGINE OIL Make sure the engine oil is at the upper level of the oil filler hole. Add oil as necessary. 700-108a 1 Upper level q 700-103c 0°C 25°C A YAMALUBE 4(10W-30) Recommended oil: å YAMALUBE 4 (10W-30) or SAE 10W-30 type SE motor oil SAE #30 ç SAE #20 SAE 10W Engine oil quantity: 0. 6 L (0. 53 lmp qt, 0. 63 US qt) NOTE: Recommended engine oil classification: API Service "SE" or "SF". D SAE 10W C SAE #20 B SAE #30 32°F 80°F 700-065 cC The generator has been shipped without engine oil. Fill with oil or it will not start. 700-006 AE00241 GROUND (Earth) Make sure to ground (earth) the generator. Check "SAFETY INFORMATION" on page 6. 741-059 ­ 13 ­ AE00955 OPERATION q NOTE: The generator has been shipped without engine oil. Fill with oil or it will not start. 700-006a A 1 Upper level AE00989 STARTING THE ENGINE NOTE: 9 Before starting the engine, do not connect any electric devices. 9 Turn the economy control switch to the "3" (OFF) position. å EF2800i YG2800i 761-073 761-062a B 1 3 "OFF" q 763-126b 1. Turn the fuel cock lever to the "ON" position. 1 "ON" q 705-037 2. Turn the engine switch to the "7" (ON) position. q 1 7 "ON" 763-084h ­ 14 ­ 3. Pull the choke knob fully out. 1 Choke knob q 701-047b NOTE: The choke is not required to start a warm engine. Push the choke knob in to the original position. Pull slowly on the recoil starter until it is engaged, then pull it briskly. After the engine starts, warm up the engine until the engine does not stop when the choke knob is returned to the original position. 704-016 6. Push the choke knob back to the original position. 701-047a NOTE: When starting the engine in areas where the ambient temperature is below 0°C (32°F), the engine automatically operates at the rated r/min (3, 600 r/min) for three minutes to warm up the engine regardless of the economy control switch position. The economy control unit operates normally afterwards if the economy control switch is turned to "I" (ON). ­ 15 ­ AE01000 APPLICATION RANGE AC DC Power factor 1 0. 8­0. 95 0. 4­0. 75 (Efficiency 0. 85) Rated voltage 12V Rated current 10A EF2800i YG2800i ­2, 500W ­2, 000W ­850W NOTE: 9 "­" means below. 9 Application wattage indicates when each device is used by itself. [. . . ] 9 To prevent FIRE HAZARDS be sure to place the spark plug as far way as possible from the spark plug hole and carburetor area. 9 To prevent ELECTRIC SHOCK do not hold spark plug lead with hand while testing. J Engine starts. L Incorrect Replace or Adjust Gap. M OK Clean the spark plug. N Check the following O Clogged 9 Fuel cock clogging 9 Air cleaner element P OK clogging. ­ 32 ­ Q Clean or Replace; Consult a Yamaha dealer. [. . . ]