User manual YAMAHA KP120

[. . . ] · Do not use or keep the product in places with extremely high temperature (places in direct sunlight, close to a heater, in a closed car, etc. ) or damp (bathroom, outside on a rainy day, etc. ). It may result in deformation, discoloration, damage or deterioration. · To clean the product, please wipe with a soft cloth or a damp cloth that has been wrung out thoroughly. [. . . ] As shown in the illustrations, remove the wing bolts and attach the riser and legs. Use the tuning key to loosen the adjustment bolts, then extend the four legs and tighten the bolts loosely. * A drum tuning key will be required for assembly. 3. Make slight adjustments to the pedal's position and the beater length so that beater strikes the pad at its center. LEVEL Wing Bolt for Legs Wing Bolt for Legs Beater Beater (Double Pedal) Hoop Washer Washer Washer Washer Spring Washer Tuning Bolt Spring Washer Wing Bolt for Riser 2. Attach your foot pedal to the KP120. Adjust the legs so that the surface of the KP120's pad is vertical when the foot pedal is attached and the kick pad and pedal are stable when the pedal is used to strike the pad. After leg length has been determined, tighten the bolts firmly to secure. LEVEL Loosen Adjustment Bolt NOTE : A double foot pedal setup (YAMAHA: DFP-880, etc. ) can also be used. When a double foot pedal setup is used on the KP120, the position of the pedal and length of the beaters should be adjusted so that the point between the two beaters is positioned at the pad's center. NOTE : Use the legs with their non-slip spurs at the ends of the legs exposed, if the drum is setup on a platform or marks on the floor are no problem. If you don't want to leave marks on the floor, use the legs with the spurs at the ends of the legs covered with the rubber ends. Extend Riser NOTE : Drum head tension can be adjusted by tightening or loosening the tuning bolts on the hoop with a drum key. However, there will be no change in the tone produced by the DTXTREME/DTX/DTXPRESS, etc. NOTE : Please make sure that head tension is even all the way around the head. Uneven tension may produce wrinkles, which may shorten the life of the drum head. Beater NOTE : Never tighten or loosen the drum head more than necessary. Over tightening may result in damage to the drum head, shell, etc. An overly loosened head may result in a shorter life of the drum head, cushion, or noise. Legs Leg Rubber Non-Slip Spur I Connections Use the supplied monaural phone cable to connect the pad's OUTPUT jack to the Input (KICK, e t c . ) j a ck o n t h e D T X T R E M E / D T X / DTXPRESS. [. . . ] Disposal Notice: Should this product become damaged beyond repair, or for some reason its useful life is considered to be at an end, please observe all local, state, and federal regulations that relate to the disposal of products that contain lead, batteries, plastics, etc. If your dealer is unable to assist you, please contact Yamaha directly. NAME PLATE LOCATION: The name plate is located on the bottom of the product. [. . . ]