User manual YAMAHA KP125W

[. . . ] · Be sure to securely tighten fixing bolts and other fasteners whenever setting up this product. In addition, any bolts that have come loose should be immediately tightened. If these precautions are not observed, the product may fall or topple over, resulting in injury or equipment damage. [. . . ] As specifications, hardware, and optional extras may not be the same in every region, please check with your Yamaha dealer. Information for Users on Collection and Disposal of Old Equipment This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC. By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. [For business users in the European Union] If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [Information on Disposal in other Countries outside the European Union] This symbol is only valid in the European Union. If you wish to discard these items, please contact your local authorities or dealer and ask for the correct method of disposal. 3 Assembling the KP125W 1. Align the mark on each leg q with the mark on the leg base w as shown in the figure below. Place a washer r on each wing bolt e, and firmly tighten the wing bolts to secure the legs to the pad unit. When playing the KP125W, lower the anti-slip stoppers t, y so that they can grip the platform or floor. If, however, the floor surface must not be marked or scratched, remove anti-slip stoppers t and retract the pointed tips of anti-slip stoppers y by turning the rubber legs housing them. When anti-slip stoppers are rendered ineffective in this way, the pad unit will be more likely to move during performances. We recommend, therefore, that a mat or the like be used instead to protect the floor. CAUTION · The pointed tips of the anti-slip stoppers are sharp. Special care should, therefore, be taken when turning the rubber legs. 2. Connect your foot pedal to the KP125W. CAUTION · Be sure to support the KP125W unit by hand when connecting or disconnecting a foot pedal in order to prevent it from toppling over. 3. Adjust the length of the legs. Loosen each of the bolts u using a drum key, and with the foot pedal connected, set the length of the legs such that the striking surface of the KP125W is vertical. [. . . ] (See Making Connections. ) Check the pad's output level. If this level is too low, use the level adjuster to increase it. (See Adjusting the Output Level. ) Two or more sounds are produced in response to a single strike (i. e. , double-triggering). [. . . ]