User manual YAMAHA LP-255 ASSEMBLY INSTRUCTIONS

[. . . ] Please keep this manual in a safe and handy place for future reference. ρ Be careful not to confuse any of the parts, and be sure to install all parts in the correct direction. Please assemble according to the sequence given below. [. . . ] For information on stand assembly, refer to the Assembly Instructions supplied with the stand. ρ Have a Phillips-head (+) screwdriver of the appropriate size ready. The parts shown in the “Assembly Parts” illustration will be used. Follow the assembly instructions and select the parts as needed. Z • The illustrations as shown in this Assembly Instructions are for instructional purposes only, and may appear somewhat different from those on your unit or keyboard. € For the functions and usage of the pedal unit, refer to the Owner’s Manual of your LP-255 compatible instrument. € この組立説明書に掲載されているイラストは、手順説明のためのものです。そのため、実際の 仕様と異なる場合があります。 • ペダルユニットの機能や使い方については、対応楽器に付属の取扱説明書をご覧ください。 z Mount the mounting board to the pedal section. Z-1 Set the long board (q) onto the pedal section (w), with the side of the board not having screw holes facing front. Z-2 Insert the two long screws (e) through the spacers (y), and then temporarily secure the pedal section (w) to the board (q) from the rear, using these screws. Fm Page 2 Monday, September 9, 2013 5:41 PM 2 x-1 x Fix the pedal unit to the keyboard stand. Keyboard Stand Keyboard-Ständer Support de clavier Soporte de teclado キーボードスタンド x x-1 Attach the angle bracket (u) to the lower side of preassembled stand part B (see Illustration x-1), using the short screws (r). X-2 Fit the assembled pedal unit between stand parts B and into the recesses in the stand bases (see Illustration x-2), to cover the angle brackets (u) attached in step x-1 from above. (u) を上から覆うよう に、ペダルユニットを足板(図 x-2 参照)の凹部にはめ 込みます。 A B r Short screws Kurze Schrauben Vis courtes Tornillos cortos 短いネジ B • If you have difficulty in fitting the pedal unit into the keyboard stand, slightly loosen the six screws securing stand part A (see Illustration x-2). 3 • The location or the angle of the [PEDAL UNIT] jack may differ depending on your keyboard. HINWEIS x-3 Fix the pedal unit from the rear, using the four thin screws (t). X-2 Pedal Unit Pedaleinheit Unité des pédales Unidad de pedal ペダルユニット Fixing screws for stand part A Befestigungsschrauben für Teil A des Ständers Fixation des vis de la partie A du support Tornillos de fijación para la parte A del soporte スタンド A 固定ネジ c Connectez la fiche du cordon du pédalier au clavier. [. . . ] By disposing of these products correctly, you will help to save valuable resources and prevent any potential negative effects on human health and the environment which could otherwise arise from inappropriate waste handling. For more information about collection and recycling of old products, please contact your local municipality, your waste disposal service or the point of sale where you purchased the items. [For business users in the European Union] If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information. [. . . ]