User manual YAMAHA LP-5 ASSEMBLY INSTRUCTIONS

[. . . ] Please assemble in accordance with the sequence given below. [. . . ] · Assembly should be carried out by at least two persons. · Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. · Be sure to tighten up all screws upon completing assembly of each unit. (identical) Left side panel Attachments 1 After making sure that the keyboard and the stand are both facing in the same direction, place the keyboard on the stand so that the holes of the stand are aligned with the holes in the bottom of the keyboard. Note: Be careful not to let your finger get caught between the stand and the keyboard. Do not hold the LP-5 in the shaded areas, to avoid getting your fingers caught. Hand Bottom of the keyboard Hand Hand Hand 4 pcs. Danger Danger 3 Attach the upper beam and cap (D). Notes: Tighten four long screws (A) loosely at first, then do them hardly to set each screw in place correctly. When inserting the screws, turn them in loosely at first, then tighten them after making sure the upper beam is positioned correctly. Slide the keyboard from rear to front as your place it on the stand to align the bolt holes. 1 Secure the upper beam with long screws (A). Correct tightenning 2 Attach the caps (D). Insufficient tightenning 2 Secure the keyboard using the knob bolts (E). Note: Do not tighten the bolts until all four bolts are in place. M. D. G. , Pro Audio & Digital Musical Instrument Division, Yamaha Corporation ©1994, 2003 Yamaha Corporation [. . . ] When inserting the screws, turn them in loosely at first, then tighten them after making sure the upper beam is positioned correctly. Slide the keyboard from rear to front as your place it on the stand to align the bolt holes. 1 Secure the upper beam with long screws (A). Correct tightenning 2 Attach the caps (D). Insufficient tightenning 2 Secure the keyboard using the knob bolts (E). [. . . ]