User manual YAMAHA MAJESTY250-2000

[. . . ] OWNER'S MANUAL YP250 5GM-28199-E0 EAU00001 INTRODUCTION Welcome to the Yamaha world of motorcycling!As the owner of a YP250, you are benefiting from Yamaha's vast experience in and newest technology for the design and the manufacture of high-quality products, which have earned Yamaha a reputation for dependability. Please take the time to read this manual thoroughly, so as to enjoy all your YP250's advantages. The owner's manual does not only instruct you in how to operate, inspect and maintain your scooter, but also in how to safeguard yourself and others from trouble and injury. [. . . ] The oil level should be between the minimum and maximum marks on the dipstick. If the level is low, add sufficient oil through the engine oil filler hole to reach the specified level. Engine oil replacement 1. Place an oil pan under the engine to catch the oil and remove the oil filler cap. Remove the drain bolt and drain the oil. 4. Check the washer and replace it if damaged. Install the washer and drain bolt, and then tighten the drain bolt to the specified torque. Tightening torque: Drain bolt: 20 Nm (2. 0 m0kg) NOTE: Make sure the washer is seated properly. 6-12 PERIODIC MAINTENANCE AND MINOR REPAIR 6. Fill the engine with oil and install the oil filler cap. 1 2 3 4 5 6 7 8 9 Recommended oil: See page 8-1. Oil quantity: Total amount: 1. 4 L Periodic oil change: 1. 2 L NOTE: If the oil is changed before the oil change indicator light comes on (i. e. before the 3, 000-km oil change interval is reached), be sure to reset it after changing the oil, so that it will come on at the correct time to indicate the next 3, 000-km oil replacement. To reset the oil change indicator light before it comes on, follow steps 1 and 2. Then, release the reset button and the oil change indicator light will come on for 1. 4 seconds. If it does not come on for 1. 4 seconds, repeat the procedure. 1 cC EC000030 1. Oil change indicator light reset button 8 Do not put in any chemical additives or use oils with a grade of CD or higher. Also, be sure not to use oils labeled "ENERGY CONSERVING II" or higher. 8 Be sure no foreign material enters the crankcase. Start the engine and warm it up for a few minutes. While warming up, check for oil leakage. If oil leakage is found, stop the engine immediately and check for the cause. Resetting the oil change indicator light 1. Push and hold in the reset button for 2 ~ 5 seconds. Release the reset button and the oil change indicator light will go off. 6-13 PERIODIC MAINTENANCE AND MINOR REPAIR 1 6. [. . . ] Remove the spark plug cap from the spark plug, install the spark plug and then the spark plug cap. cC ECA00015 8 Storing the scooter in a poorly ventilated room or covering it with a tarp while it is still wet will allow water and humidity to seep in and cause rust. 8 To prevent corrosion, avoid damp cellars, stables (because of the presence of ammonia) and areas where strong chemicals are stored. 7 w EWA00003 When turning the engine over, be sure to ground the spark plug electrodes to prevent damage or injury from sparking. 7-4 SCOOTER CARE AND STORAGE 6. Lubricate all control cables and the pivoting points of all levers and pedals as well as of the sidestand/centerstand. Check and, if necessary, correct the tire air pressure, then raise the scooter so that both of its wheels are off the ground. [. . . ]