User manual YAMAHA MCS2E

[. . . ] MODEL: Serial No. : The serial number is located on the rear of the unit. Retain this Owner's Manual in a safe place for future reference. 13 14 Read these instructions. Install in accordance with the manufacturer's instructions. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. [. . . ] FM GND AM 4 3 OUTPUT SYSTEM CONNECTOR L SUB WOOFER INPUT R PHONO CD AUX TO:CD PLAYER Ground (GND terminal*) * For the maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into the moist earth. Connect the supplied indoor FM antenna to the FM jack and AM loop antenna's GND terminal of the receiver. Place the antenna away from the receiver and speaker cables. Find the best reception position, expand the antenna, then fix it. Attach the antenna stand to the antenna. When attaching the antenna on the wall, you do not need to use the antenna stand. Connect the AM loop antenna lead wires to the AM and GND terminals of the receiver. There is no distinction between the two lead wires for connecting. Twist the lead wires of the AM loop antenna and the indoor FM antenna together before connecting to the GND terminal. Place the AM loop antenna away from the system and speaker cables. While listening to the radio, rotate the antenna head to find the best angle for reception. CONNECTING THE POWER CABLES Switching the voltage (Asia and Central/ South America models only) Asia and Central/ South America models only CAUTION The VOLTAGE SELECTOR on the rear panel of this system must be set for your local voltage BEFORE plugging the power cable into the AC wall outlet. · When your USB device is connected to the USB port, your USB device can be charged automatically even when the CD player is in standby mode and ECO mode is OFF (see page 13). · You can disconnect the USB device during the playback. English 11 En SYSTEM OPERATIONS SYSTEM OPERATIONS Follow the procedure below to select an input source and adjust the sound settings on the system. ON/STANDBY, OFF PURE DIRECT 3 VOLUME Press one of the input selection keys (or rotate INPUT on the front panel) to select the desired input source. Start playback on the selected source component or select a radio station. For information on the disc/USB device playback, see page 14, and for information on tuning, see page 17. Press VOL +/­ (or rotate VOLUME on the front panel) to adjust the volume to the desired output level. ON/STANDBY OFF PHONES INPUT PURE DIRECT TUNER PRESET MIN MAX 4 ON/STANDBY OFF USB INPUT VOLUME 5 To adjust the audio quality (standby/on) 1 iPod CD USB Press TONE/BALANCE to select BASS, TREBLE, or BALANCE. To adjust the setting, press or . Input selection keys FM/AM PHONO AUX PRESET 2 TUNING VOL VOL +/­ VOL BASS: Adjusts the low frequency response. TREBLE: Adjusts the high frequency response. BALANCE: Adjusts the volume level of each left and right speaker channel. Pure Direct mode TONE BALANCE TONE/BALANCE DISPLAY DIMMER SLEEP / MUTE PURE DIRECT MUTE The Pure Direct mode shuts down the tone control circuitry and front panel display, allowing you to enjoy pure high-fidelity sounds. Press PURE DIRECT (or PURE DIRECT on the front panel) to turn on the Pure Direct mode. The PURE DIRECT indicator lights up, and the front panel display goes off. Notes PURE DIRECT Basic system operations 1 2 Press ON/STANDBY, OFF on the front panel of the receiver and the CD player. [. . . ] "Made for iPod" means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards. Track A CD can be divided into a number of segments (tracks). SPECIFICATIONS R-1330 AMPLIFIER SECTION · Minimum RMS output power per channel (6 , 1 kHz, 0. 5% THD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 W + 60 W · Maximum useful output power (JEITA) [Asia, China and Korea models] (6 , 1 kHz, 10% THD) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 70 W + 70 W · Input sensitivity/Impedance CD/AUX . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 200 mV/47 k PHONO. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3. 5 mV/47 k · Frequency Response CD. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]