User manual YAMAHA MOTIF ES8

[. . . ] The software and this Installation Guide are exclusive copyrights of Yamaha Corporation. ⷠUse of the software and this guide is governed by the SOFTWARE LICENSING AGREEMENT which the purchaser fully agrees to upon breaking the seal of the software packaging. (Please read carefully the AGREEMENT at the end of this guide before installing the application. ) · Copying of the software or reproduction of this guide in whole or in part by any means is expressly forbidden without the written consent of the manufacturer. [. . . ] 4 Select the appropriate input port (for example, "YAMAHA USB IN 0-1") in the [IN] box, then click [OK] to close the dialog box. nYou can select the audio driver and the audio in/out device if necessary. From the [Setup] menu, select [Audio] [Device] to call up the "Device" page of the Some computers may take about ten seconds to show this screen after the installation is complete. 4 Click the [OK] button to close System Properties, and then click "X" in the upper right of the window to close the Control Panel. 5 Insert the included CD-ROM into the CD-ROM drive. 6 First, make sure the POWER switch on the MOTIF ES is set to OFF, then use a USB cable to connect the USB connector of the computer (or the USB hub) to the USB TO HOST connector of the MOTIF ES. When the MOTIF ES is turned on, the computer automatically displays the "Found New Hardware Wizard. " n Some computers may take a few minutes to show this screen. NThe USB connection to the MOTIF ES can only be used for transfer of MIDI data. Once you`ve installed these software programs, you can use your computer to edit the Voices and Mixing settings of the MOTIF ES. For details, refer to the each on-line Help or the each PDF owner's manual. Some computers may take about a few minutes to show this screen after the installation is complete. In the procedure of installing the SQ01 V2, you can also install the TWE, which enables you to edit the wave data directly on your computer, as plug-in software of the SQ01 V2. If you wish to install the TWE alone, follow the instructions below. 1 Double-click on the "Twe_" folder. 2 Select the language that you want to use and double-click "setup. Before setting the MIDI port on the Voice Editor or Multi Port Editor, you should set the MIDI port from the MIDI SETUP toolbar. 2 Click the MIDI Setup button in the Toolbar called up via step #1. 3 In the MIDI Setup window called up via step #2, click the [] button at the right end of each box and make the port settings as shown. In order for MIDI ports to be available here, you'll need to select the relevant MIDI port within each application software (Voice Editor or Multi Port Editor). This is the port that you'll use in the various software. A variety of applications (with installers) and data are contained in the following folders. [. . . ] Check whether the MIDI IN/OUT setting in the Utility mode corresponds to the actually used cable (USB or MIDI). The following is a legal agreement between you, the end user, and Yamaha Corporation ("Yamaha"). the enclosed Yamaha software program is licensed by Yamaha to the original purchaser for use only on the terms set forth herein. Please read this licensing agreement with care. [. . . ]