User manual YAMAHA MOTIF-RACK XS

[. . . ] OWNER'S MANUAL TONE GENERATOR EN SPECIAL MESSAGE SECTION This product utilizes batteries or an external power supply (adapter). DO NOT connect this product to any power supply or adapter other than one described in the manual, on the name plate, or specifically recommended by Yamaha. WARNING: Do not place this product in a position where anyone could walk on, trip over, or roll anything over power or connecting cords of any kind. The use of an extension cord is not recommended! [. . . ] Arp Sw (Arpeggio Switch) Arp Hold (Arpeggio Hold) Determines whether Arpeggio playback is on or off. This is the same function as the "Arp Sw" in the Arp Select display. Settings: off, on When this is set to "on, " the Arpeggio cycles automatically, even if Note Off message is received, and it continues to cycle until the next Note On message is received. Settings: sync-off, off, on sync-off. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . When set to "sync-off, " the Arpeggio playback continues to run silently, even when Note Off message is received. Receiving a Note On message turns the Arpeggio playback on again. n When receiving the MIDI sustain message (control change #64) with "Arp Sw" set to "on, " you can obtain the same result by setting "Arp Hold" to "on. " Arp Tempo (Arpeggio Tempo) Determines the Arpeggio Tempo. This parameter can be changed directly via the Knob. Settings: 5 ­ 300 n If you are using this instrument with an external sequencer, DAW software, or MIDI device, and you want to synchronize it with that device, set the "MIDI Sync" parameter in the Utility MIDI window (page 99) to "external" or "auto. " When "MIDI Sync" is set to "auto" (only when MIDI clock is transmitted continuously) or "external, " the Tempo parameter here indicates "external" and cannot be changed. Velocity Rate Determines how much the velocity of the Arpeggio playback is offset from the original value. A setting of 100% means the original velocities are used. Settings below 100% will reduce the velocities of the Arpeggio notes, whereas settings above 100% will increase them. If the resultant velocity value is less than zero it will be set to 1, and if the resultant velocity is greater than 128 it will be set to 127. Settings: 0 ­ 200% Gate Time Rate Determines how much the Gate Time (length) of the Arpeggio notes is offset from the original value. A setting of 100% means the original gate times are used. Settings below 100% will shorten the gate times of the Arpeggio notes, whereas settings above 100% will lengthen them. The Gate Time cannot be decreased beyond its normal minimum of 1; any values outside that range will automatically be limited to the minimum. Settings: 0 ­ 200% 66 MOTIF-RACK XS Owner's Manual Voice Mode Unit Multiply Settings: 50%, 66%, 75%, 100%, 133%, 150%, 200% Quantize Value Determines to what beats the note data in the Arpeggio will be aligned, or to what beats in the Arpeggio the swing is applied. The number shown at right of each value indicates the length assumes that the quarter-note resolution is 480. Settings: 260 (32nd note), 6380 (16th note triplet), 6120 (16th note), 83160 (8th note triplet), 8240 (8th note), 43320 (1/4 note triplet), 4480 (1/4 note) Setting Up Reference Quantize Strngth (Quantize Strength) Sets the "strength" by which note events are pulled toward the nearest quantize beats. A setting of 100% produces exact timing set via the "Quantize Value" parameter above. A setting of 0% results in no quantization. A setting of 50% result that the note events are pulled to the half point between the 0% and 100%. Settings: 0% ­ 100% Swing Delays notes on even-numbered beats (backbeats) to produce a swing feel. Settings above 1 delay the Arpeggio notes, whereas settings below -1 advance them. A setting of 0 produces exact timing set via the "Quantize Value. " resulting in no swing. Judicious use of this setting lets you create swing rhythms and triplet feels, such as shuffle and bounce. Settings: -120 ­ +120 Octave Range Specifies the maximum Arpeggio range in octaves. Positive value settings increase the octave range of the Arpeggio playback upward, whereas negative value settings increase it downward. Settings: -3 ­ +0 ­ +3 Settings: realtime, measure Velocity Mode Adjusts the velocity of the Arpeggio notes when receiving the Note On message. Settings: original, thru original. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The Arpeggio plays back at the preset velocities included in the Arpeggio sequence data. thru . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . The Arpeggio plays back according to the velocity of the received Note On message. Key Mode Determines how the Arpeggio plays back when receiving Note On messages. Settings: sort, thru, direct, sort+direct, thru+direct sort . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Yamaha Music Indonesia (Distributor) PT. Nusantik Gedung Yamaha Music Center, Jalan Jend. 4, Jakarta 12930, Indonesia Tel: 21-520-2577 SPAIN/PORTUGAL Yamaha Música Ibérica, S. A. 17, 200, 28230 Las Rozas (Madrid), Spain Tel: 91-639-8888 KOREA Yamaha Music Korea Ltd. [. . . ]